M.A. Ford
M.A. Ford 15068750 2 Flute Ball Nose End Mill 11/16
Two-flute ball-nose end mill with 11/16 inch cutting diameter for contour milling
- 2-flute design enables efficient chip evacuation in deep slots
- ball nose profile produces smooth 3-D contours and radii
- 11/16 inch diameter suits medium-scale profiling tasks
- TuffCut GP series built for general-purpose milling applications
- California Proposition 65 notice discloses regulated chemical content
Tuffcut GP 2 Flute Ball Nose 11/16
This M.A. Ford end mill is a new cutting tool designed for contouring and profiling operations. The two-flute geometry suits general-purpose milling in a variety of materials. It targets machinists and fabricators who need a reliable ball nose profile for 3D surfacing work. Buyers requiring higher flute counts for finishing passes or specific coating technologies should verify compatibility separately.
Thermals noise and power draw
Thermal output and acoustic signature depend entirely on the host machine spindle speed feed rate and workpiece material. The tool itself generates no independent noise or power consumption. Cutting forces and heat buildup are managed through the machine tool's coolant strategy and rigidity. Operators should monitor conditions specific to their application.
Tuffcut GP series benefits
The Tuffcut GP designation indicates a general-purpose substrate and geometry optimised for versatility across material groups. This allows a single tool to handle roughing and semi-finishing contours without frequent tool changes. The ball nose profile enables smooth radius generation in profiling toolpaths. No additional coatings or accessories are included with this item.
Highlights
- 2-flute design enables efficient chip evacuation in deep slots
- ball nose profile produces smooth 3-D contours and radii
- 11/16 inch diameter suits medium-scale profiling tasks
- TuffCut GP series built for general-purpose milling applications
- California Proposition 65 notice discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 11/16 inch shank into my tool holder without run-out?
Clean the shank and holder bore, then tighten the collet or set-screw evenly so the 11/16 shank seats fully; the step most people skip is verifying zero run-out with a dial indicator before cutting.
When will the 2-flute ball nose need replacement?
Replace the end mill when the ball radius shows visible flank wear or chipping that degrades surface finish; re-sharpening is possible but restores geometry only a limited number of times.
What limit appears first during prolonged profiling cuts?
Heat buildup at the ball tip reduces edge hardness fastest, so tool life ends when the cutting temperature exceeds the carbide grade’s hot-hardness threshold.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
