We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small silver cylindrical end mill with two spiral flutes and rounded tip

M.A. Ford

M.A. Ford 15006000 Tuffcut Gp 2 Flute Ball Nose End Mill .0600 pneumatic accessory

SKU CH-1XBX-0HMJW

Two-flute ball-nose end mill cuts precise contours in metal and plastic

  • 2-flute ball nose cuts precise contours
  • TuffCut GP series built for tough materials
  • .0600 diameter suits fine detail work
  • New condition delivers full factory performance
  • California Prop 65 warning lists cancer and reproductive risks

Product Identity

The M.A. Ford 15006000 is a TuffCut GP series two-flute ball nose end mill designed for general-purpose milling. It is supplied new as a pneumatic accessory for use with compatible power tools.

Who This Suits

This cutter suits machinists and maintenance teams needing a small-diameter ball nose tool for contouring and finishing operations. It is not for buyers who need a larger cutting diameter, a different flute count, or a tool optimised for a specific high-performance material.

Setup Checks

Verify that your tool holder and machine spindle accept the shank size required by this end mill. Confirm the workpiece material and cutting parameters match the capabilities of a general-purpose two-flute geometry. Note the California Proposition 65 warnings regarding chemical exposure.

Highlights

  • 2-flute ball nose cuts precise contours
  • TuffCut GP series built for tough materials
  • .0600 diameter suits fine detail work
  • New condition delivers full factory performance
  • California Prop 65 warning lists cancer and reproductive risks

Specifications

BrandM.A. FORD

Questions about this item

Does the M.A. Ford 15006000 end mill fit the collet size of my pneumatic die grinder?

The cutter shank must match your die grinder's collet diameter; verify the collet size on your tool before use.

Will the 15006000 work in an older pneumatic tool that runs at lower spindle speeds?

The 2-flute ball nose geometry cuts in many materials, but feed rate and spindle speed should suit the workpiece and tool condition.

How can I confirm the 15006000 is cutting correctly after installation?

Check for smooth chip evacuation, consistent surface finish, and absence of chatter during the first pass.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.