M.A. Ford
M.A. Ford 15002000 Tuffcut GP 2 flute ball nose end mill .0200 pneumatic accessory
Two-flute ball-nose end mill for precision contour milling in a variety of materials
- 2-flute ball nose design enables precise contour milling
- Tuffcut GP series built for general-purpose machining
- .0200 diameter suits fine-detail work
- M.A. Ford brand recognised for cutting-tool quality
- California Prop 65 notice included for regulatory awareness
Tuffcut GP 2 flute ball nose
The M.A. Ford 15002000 is a solid-carbide end mill designed for general-purpose milling in a range of materials. Its two-flute geometry and ball-nose profile suit contouring, slotting and profiling operations on CNC or manual machines.
Machinists needing a .0200 ball nose
This cutter suits shops that require a small-radius ball nose for detailed 3D work or finishing passes. It is not for users who need a larger diameter, more flutes for heavy roughing, or a corner-radius or square-end geometry.
California Proposition 65 notice included
The supplier flags that the product contains a chemical known to the State of California to cause cancer and reproductive harm. No additional accessories, coatings or software are bundled with the end mill.
Highlights
- 2-flute ball nose design enables precise contour milling
- Tuffcut GP series built for general-purpose machining
- .0200 diameter suits fine-detail work
- M.A. Ford brand recognised for cutting-tool quality
- California Prop 65 notice included for regulatory awareness
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What collet or chuck size accepts the .0200 shank of this Tuffcut GP end mill?
Use a precision ER collet or shrink-fit holder sized for a .0200 inch shank; the tool has no larger shank section so the holder must grip that exact diameter.
Will the 2-flute ball nose geometry clear chips in the same pockets I cut with a 4-flute end mill?
The two-flute design provides larger flute gullets than a four-flute tool, improving chip evacuation in deep, small-radius pockets.
How can I verify the 15002000 end mill is cutting true after installation?
Run a light test pass on scrap material and measure the resulting radius with a calibrated gauge; a consistent .0200 radius confirms correct run-out and tool engagement.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
