M.A. Ford
M.A. Ford 14039370C 10.0 mm 4 flute ball nose end mill
A 10.0 mm four-flute ball nose end mill for contouring and finishing in milling operations
- 4-flute design for smoother contour finishing
- 0 mm diameter suits medium milling tasks
- Ball nose geometry enables 3D profiling cuts
- TuffCut GP series built for general-purpose use
- California Prop 65 chemical warning applies
10 mm ball nose end mill
The M.A. Ford 14039370C is a 10.0 mm diameter ball nose end mill with four flutes. It belongs to the Tuffcut GP range of power and pneumatic accessories. The tool is designed for general-purpose milling operations in a workshop environment. It suits machinists who need a new cutter for profiling and contouring tasks.
California Proposition 65 notice
This product carries a California Proposition 65 warning for exposure to a chemical known to cause cancer. A second warning covers a chemical known to cause birth defects or other reproductive harm. The notices apply to the item as supplied by the manufacturer. Users should follow standard shop safety practices when handling the cutter.
Tuffcut GP series construction
The cutter is shipped new directly from the manufacturer. Its four-flute geometry and ball nose profile support smooth contour cuts in a variety of materials. The shank fits standard tool holders for 10 mm milling cutters. No additional mounting hardware or accessories are included with the tool.
Highlights
- 4-flute design for smoother contour finishing
- 0 mm diameter suits medium milling tasks
- Ball nose geometry enables 3D profiling cuts
- TuffCut GP series built for general-purpose use
- California Prop 65 chemical warning applies
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How do I install the 10.0 mm ball nose end mill in a collet or holder without causing runout?
Clean the shank and collet bore, insert the tool to the recommended depth, and tighten the collet nut evenly with a torque wrench to avoid eccentric clamping.
What maintenance or replacement will the 4 flute TuffCut GP end mill need over time?
Inspect the ball nose and flutes for chipping or flank wear after each job; replace the cutter when edge damage appears or surface finish deteriorates.
What limit appears first on the 10.0 mm carbide end mill during sustained high-speed profiling?
Heat buildup at the ball radius accelerates flank wear and can cause micro-chipping, so cutting speed and feed must stay within the tool’s recommended range.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
