M.A. Ford
M.A. Ford 14039370A 4 Flute Ball Nose End Mill 10.0Mm
Four-flute ball nose end mill for contour milling with a 10.0 mm cutting diameter
- 4-flute design enables smoother contour cuts
- 0 mm ball nose suits precise 3D profiling
- TuffCut GP geometry extends tool life in steel
- M.A. Ford manufacturing ensures consistent flute spacing
- California Prop 65 warning informs safe handling practice
Tuffcut GP 4-Flute Ball Nose
This M.A. Ford end mill is a 10.0 mm carbide cutting tool designed for contouring and profiling in CNC milling operations. The four-flute geometry provides stability and a smooth finish on ferrous and non-ferrous metals. Machinists and toolrooms select it for general-purpose production work requiring reliable material removal.
Upgrading from two-flute or general-purpose cutters
Switching to this four-flute design increases feed rates and reduces vibration compared to two-flute tools in slotting and pocketing. The jump is worthwhile when cycle time matters and the machine spindle has sufficient rigidity to handle the higher chip load. Shops running older, less rigid setups may not see the full benefit.
Sustained load performance
The four flutes distribute cutting forces evenly, keeping temperatures lower during extended passes in steel or aluminium. Consistent chip evacuation prevents re-cutting and protects the carbide edge from premature wear. Operators should monitor coolant flow to maintain this stability throughout long production runs.
Highlights
- 4-flute design enables smoother contour cuts
- 0 mm ball nose suits precise 3D profiling
- TuffCut GP geometry extends tool life in steel
- M.A. Ford manufacturing ensures consistent flute spacing
- California Prop 65 warning informs safe handling practice
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What shank size does the 10.0 mm M.A. Ford 14039370A end mill require for my tool holder?
The cutter has a 10.0 mm diameter, so it needs a 10.0 mm collet or shrink-fit holder with matching bore.
What is the correct way to clamp this 4-flute ball-nose mill to avoid run-out?
Tighten the collet nut to the holder maker’s torque spec while the shank is fully seated; the common error is leaving a gap between shank and collet face.
When should I replace the M.A. Ford 14039370A once the ball nose wears down?
Replace it when the radius shows visible flats or when finish quality drops, typically after the flank wear reaches the tool maker’s regrind limit.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
