M.A. Ford
M.A. Ford 14012500GX 3/32 4 Flute Ball End Mill TiCN pneumatic accessory
3/32-inch four-flute ball end mill with TiCN coating for contoured milling in pneumatic applications
- 4-flute design gives smoother finish on contours
- Ball-nose profile suits 3-D profiling and radius work
- TiCN coating extends tool life in abrasive materials
- 3/32 inch diameter fits tight-detail milling jobs
- California Prop 65 notice discloses regulated chemical content
M.A. Ford 14012500GX ball end mill
The M.A. Ford 14012500GX is a 3/32 inch diameter ball end mill with four flutes and a TiCN coating. It is intended for machinists and engineers performing contouring or profiling work in a range of materials using CNC or manual milling equipment.
3/32 inch diameter with TiCN coating
The small 3/32 inch cutting diameter suits fine detail work and tight radii where larger tools cannot reach. Four flutes provide a balance of chip evacuation and surface finish, while the TiCN coating adds hardness and heat resistance to extend tool life in abrasive or moderately difficult alloys.
California Proposition 65 notice included
The product carries a California Proposition 65 warning stating it contains a chemical known to the state to cause cancer, birth defects, or other reproductive harm. This regulatory notice informs safe handling practices but does not alter the tool’s cutting performance or coating properties.
Highlights
- 4-flute design gives smoother finish on contours
- Ball-nose profile suits 3-D profiling and radius work
- TiCN coating extends tool life in abrasive materials
- 3/32 inch diameter fits tight-detail milling jobs
- California Prop 65 notice discloses regulated chemical content
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
Will the 14012500GX 3/32 4 flute ball end mill fit my existing pneumatic tool holder?
The 3/32 inch shank diameter matches standard collets used on many pneumatic die grinders and rotary tools; verify your collet size before use.
How can I confirm the TiCN coating on the 14012500GX is performing correctly after installation?
A consistent gold-violet hue on the flutes and reduced edge wear during aluminium or steel profiling indicate the TiCN layer is intact.
Does the 14012500GX package include any collets, wrenches or lubricant, or must I buy them separately?
Only the single 4 flute ball end mill is supplied; collets, tool holders and cutting fluid are sold separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
