M.A. Ford
M.A. Ford 1370AP Cyclone Xd Coolant Fed Double Margin Drill 13.70mm
Coolant-fed double-margin drill, 13.70 mm diameter, for precise deep holes
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 70 mm diameter suits precise drilling tasks
- Cyclone Xd 3X geometry enhances cutting performance
- M.A. Ford brand delivers professional tool reliability
Cyclone Xd 13.70mm Coolant Drill
This M.A. Ford Cyclone Xd drill is a 13.70mm double margin tool with internal coolant feed. It is built for high-performance drilling in demanding materials. The 3X design supports efficient chip evacuation and hole accuracy. Professional machinists use it for precise, repeatable results.
Suited for coolant-fed machines only
Shops without through-spindle coolant capability cannot use this drill effectively. Buyers needing a standard twist drill without coolant channels should select a different style. The double margin geometry requires rigid setups for best performance. Hand-held or low-rigidity applications are not appropriate.
13.70mm diameter with double margin
The 13.70mm cutting diameter and double margin configuration determine hole size and stability. This specific geometry controls straightness and finish in deep holes. Verify the exact diameter matches your required hole tolerance before ordering. No other diameter or margin option is available for this part.
Highlights
- Coolant-fed design clears chips efficiently
- Double margin construction improves hole accuracy
- 70 mm diameter suits precise drilling tasks
- Cyclone Xd 3X geometry enhances cutting performance
- M.A. Ford brand delivers professional tool reliability
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
What size drill chuck or collet is needed for the 13.70 mm shank?
A 13.70 mm collet or chuck with matching capacity is required to hold the drill securely.
How do I connect the coolant feed on this Cyclone Xd drill?
Attach the machine's coolant hose to the drill's through-shank coolant port using the correct adapter for your spindle.
When should the double-margin drill be resharpened or replaced?
Replace or regrind when flank wear reaches the margin width or when hole size and finish fall outside tolerance.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
