M.A. Ford
M.A. Ford 13650006 Garden Statue
A two-flute end mill finisher for aluminium cutting, 1/2 size, model 13650006
- TypeCutting Tools
- Precision finishing with two-flute end-mill design
- TuffCut Al series engineered for aluminium milling
- 1/2-inch shank fits standard tool holders
- New condition ensures full factory performance
- California Prop 65 chemical-hazard disclosure included
M.A. Ford 13650006 End Mill
The M.A. Ford 13650006 is a two-flute end mill designed for finishing aluminium workpieces. It serves machinists and fabricators who require a dedicated tool for non-ferrous material removal. The cutter geometry targets clean surface finishes on softer alloys. This item is supplied new and carries California Proposition 65 warnings for cancer and reproductive harm.
Sustained Cutting Behaviour
The two-flute configuration provides large chip gullets that evacuate aluminium swarf efficiently during extended passes. This reduces the tendency for chips to weld to the cutting edges when the tool dwells in the cut. Consistent flute engagement helps maintain dimensional stability across the workpiece length. Heat buildup is managed by the open geometry rather than specialised coatings.
Replacing General-Purpose Cutters
Shops moving from multi-material end mills to this aluminium-specific finisher gain sharper edge preparation and polished flutes suited to sticky alloys. The upgrade is justified when cycle time or surface finish on aluminium becomes a bottleneck. It does not address the needs of buyers who require tools for hardened steels, high-temperature alloys or high-feed roughing strategies.
Highlights
- Precision finishing with two-flute end-mill design
- TuffCut Al series engineered for aluminium milling
- 1/2-inch shank fits standard tool holders
- New condition ensures full factory performance
- California Prop 65 chemical-hazard disclosure included
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 13650006 end mill generate noticeable heat or vibration during extended cutting sessions?
The Tuffcut Al 2 Flute Finisher is designed for aluminium alloys and non-ferrous materials, so it runs cooler and with less chatter than general-purpose cutters when feed and speed are matched to the workpiece.
What tool holder or collet size is required to run the 13650006?
The cutter has a 1/2 inch shank, so you need a 1/2 inch collet, end-mill holder or shrink-fit chuck that matches your machine spindle taper.
Can the 13650006 be used on an older manual knee mill with R8 spindle?
Yes, provided you fit an R8-to-1/2-inch collet or end-mill adapter and run the lower RPM range suitable for the machine rigidity.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
