M.A. Ford
M.A. Ford 13631250 Garden Statue
A 5/16 inch Tuffcut Al two-flute end mill finisher for aluminium machining
- TypeCutting Tools
- Tuffcut Al coating extends tool life for aluminium finishing
- Two-flute geometry clears chips efficiently in non-ferrous materials
- 5/16 inch diameter suits a wide range of milling operations
- California Proposition 65 warning informs safe handling practices
- Brand new condition ensures full factory performance from first use
M.A. Ford 13631250 end mill
The M.A. Ford 13631250 is a Tuffcut Al two-flute end mill finisher sized at 5/16 inch. It is designed for machinists and fabricators who need a dedicated finishing tool for aluminium workpieces. The cutter suits CNC and manual milling operations where surface quality matters.
Two-flute geometry for aluminium finishing
The two-flute design provides generous chip clearance when cutting soft, gummy aluminium alloys. This geometry reduces the risk of built-up edge and helps maintain a clean surface finish during high-speed passes. The tool is supplied new and ships directly from the manufacturer.
Verify holder capacity and chemical warnings
Before ordering, confirm that your tool holder or collet accepts a 5/16 inch shank diameter. The product carries California Proposition 65 warnings for chemicals known to cause cancer and reproductive harm, so appropriate personal protective equipment and ventilation should be used.
Highlights
- Tuffcut Al coating extends tool life for aluminium finishing
- Two-flute geometry clears chips efficiently in non-ferrous materials
- 5/16 inch diameter suits a wide range of milling operations
- California Proposition 65 warning informs safe handling practices
- Brand new condition ensures full factory performance from first use
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What cutting standard does the 13631250 end mill follow for aluminium finishing?
The 13631250 is a Tuffcut Al two-flute finisher ground to a 5/16 diameter for aluminium alloys.
What shank and holder dimensions does the 5/16 finisher require?
A 5/16 shank fits standard ER, Weldon or shrink-fit holders made for that diameter.
How is the 13631250 installed and what step is often missed?
Clamp the shank fully in a matched collet, verify run-out, then apply the correct feed per tooth for aluminium.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
