M.A. Ford
M.A. Ford 13612503 Tuffcut Al End Mill Finisher 1/8
A precision 2-flute end mill finisher for aluminium milling, 1/8 inch diameter
- TypeCutting Tools
- Tuffcut Al design for aluminium finishing cuts
- 2 flute geometry clears chips efficiently in soft metals
- 1/8 inch diameter suits precision milling tasks
- California Prop 65 warning lists cancer risk chemical
- California Prop 65 warning lists reproductive harm chemical
M.A. Ford 13612503 end mill
This M.A. Ford 13612503 Tuffcut Al end mill is a two-flute finisher designed for aluminium milling. It suits machinists and fabricators who need clean surface finishes on non-ferrous workpieces. The tool is sold new and ships directly from the manufacturer.
1/8 diameter cutting capacity
The 1/8 inch diameter provides precise material removal in aluminium alloys and similar soft metals. It handles finishing passes where tight tolerances and smooth surfaces are required. The two-flute geometry limits chip evacuation in deep slots or heavy roughing operations.
California Proposition 65 notice
This product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm. Buyers who require materials without such substances should select an alternative tool. The warning applies to the item as supplied by M.A. Ford.
Highlights
- Tuffcut Al design for aluminium finishing cuts
- 2 flute geometry clears chips efficiently in soft metals
- 1/8 inch diameter suits precision milling tasks
- California Prop 65 warning lists cancer risk chemical
- California Prop 65 warning lists reproductive harm chemical
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Will the 13612503 end mill fit the 1/8 inch collet on my older milling machine?
The 13612503 is a 1/8 inch shank tool, so it will fit any standard 1/8 inch collet or tool holder you already use.
How can I confirm the Tuffcut Al finisher is cutting correctly after installation?
You should see a smooth surface finish on aluminium with minimal chatter and consistent chip evacuation from the two flutes.
Does the 13612503 come with any tool holders or just the end mill itself?
The package contains the 2 flute end mill finisher only; collets, holders or tooling accessories must be purchased separately.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
