M.A. Ford
M.A. Ford 13598405N5 Tuffcut Al 2 Flute End Mill Necked 25.0mm statue
A 25.0 mm necked two-flute end mill for aluminium, supplied new with California Proposition 65 warnings
- TypeCutting Tools
- California Proposition 65 warning informs safe handling
- 0 mm necked design enables deep cavity reach
- Two-flute geometry clears chips in aluminium cuts
- M.A. Ford brand signals industrial-grade tool quality
- New condition ensures full factory performance life
M.A. Ford 25.0mm End Mill
This M.A. Ford end mill is a new cutting tool designed for aluminium work. The necked two-flute geometry supports chip evacuation in deep cavities. It carries the manufacturer part number 13598405N5 and is sold individually.
For aluminium milling only
Machinists who need a dedicated aluminium cutter with neck clearance will find this tool suitable. Workshops cutting steel, titanium or hardened materials should look at a different tool. Buyers who require a multi-flute finisher or a coated variant for abrasive alloys will not be served by this item.
25.0mm cutting diameter capacity
The 25.0mm diameter provides substantial material removal in a single pass. Two flutes limit feed rates compared with higher-flute tools when surface finish is critical. The necked shank gives reach but reduces rigidity in very long overhangs. California Proposition 65 warnings apply to this product.
Highlights
- California Proposition 65 warning informs safe handling
- 0 mm necked design enables deep cavity reach
- Two-flute geometry clears chips in aluminium cuts
- M.A. Ford brand signals industrial-grade tool quality
- New condition ensures full factory performance life
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter must my tool holder accept for this 25.0 mm necked end mill?
The cutter is a 25.0 mm necked end mill, so the holder must accommodate that shank size.
Will the 2-flute necked geometry interfere with an older 3-flute cutter in the same turret?
Each tool occupies its own turret station, so the 2-flute necked cutter will not mechanically clash with a 3-flute tool stored elsewhere.
How can I verify the 25.0 mm necked end mill is cutting correctly after setup?
Check for consistent chip formation, stable spindle load and the expected surface finish on the workpiece.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
