M.A. Ford
M.A. Ford 13562990N 16.0 mm Garden Statue
A 16.0 mm Tuffcut Al two-flute necked end mill for aluminium machining
- TypeCutting Tools
- Designed for aluminium machining with two-flute geometry
- 0 mm cutting diameter for precise milling
- Necked shank allows deeper cavity access
- TuffCut AL coating reduces built-up edge
- California Proposition 65 warning for chemical exposure
M.A. Ford 16.0 mm End Mill
The M.A. Ford 13562990N is a Tuffcut Al 2 Flute End Mill with a necked design and a 16.0 mm cutting diameter. It is a new cutting tool intended for machining operations. The product carries California Proposition 65 warnings regarding cancer and reproductive harm.
Machinists needing aluminium tooling
This tool suits machinists working with aluminium alloys who require a two-flute geometry for chip evacuation. It is not for buyers who need a higher flute count for finishing passes or a different helix angle for specific materials. The necked profile limits use in shallow pockets without reach clearance.
16.0 mm diameter capacity
The 16.0 mm diameter handles medium-sized slots and profiles in aluminium. Headroom decreases when deeper axial cuts are required beyond the flute length. The two-flute design restricts feed rates compared to multi-flute cutters in harder materials.
Highlights
- Designed for aluminium machining with two-flute geometry
- 0 mm cutting diameter for precise milling
- Necked shank allows deeper cavity access
- TuffCut AL coating reduces built-up edge
- California Proposition 65 warning for chemical exposure
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the 16.0 mm shank fit my existing ER collet or milling chuck?
The 16.0 mm diameter shank requires a matching 16.0 mm collet, hydraulic holder or shrink-fit chuck; verify your tool-holder range before use.
Can I run this necked end mill in the same aluminium roughing passes I use for standard-length tools?
The necked design gives extra reach for deep pockets, but keep radial engagement conservative and use climb milling to avoid deflection in longer overhangs.
How do I confirm the Tuffcut Al coating is performing correctly after the first cuts?
Look for a consistent gold-coloured wear land, chip evacuation without built-up edge, and surface finish that stays bright — any darkening or chatter means adjust feed or speed.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
