M.A. Ford
M.A. Ford 13555122N 14.0 mm End Mill
A 14.0 mm necked two-flute end mill designed for aluminium cutting tasks
- TypeCutting Tools
- Tuffcut Al coating extends tool life in aluminium
- 2 flute design improves chip evacuation at 14.0 mm diameter
- Necked profile allows deeper cavity reach without interference
- California Proposition 65 warning for cancer risk
- California Proposition 65 warning for reproductive harm risk
14.0 mm necked end mill for aluminium
The M.A. Ford 13555122N is a two-flute TuffCut AL end mill designed for machining aluminium alloys. Its necked profile provides extra reach in deep cavities without sacrificing rigidity. The tool is supplied new and intended for CNC milling operations where chip evacuation and surface finish are critical.
Two-flute geometry optimised for aluminium
The single specification that determines suitability is the two-flute design with a 14.0 mm cutting diameter. This geometry creates large chip gullets that prevent clogging in soft, sticky materials. Using a higher flute count would trap chips and degrade finish quality in aluminium.
Suited for CNC operators cutting non-ferrous metals
This cutter suits shops profiling or slotting aluminium, brass or plastic parts on a milling machine. It is not for buyers who need a tool for hardened steel, titanium or high-temperature alloys. It also does not suit manual milling without rigid workholding and coolant control.
Highlights
- Tuffcut Al coating extends tool life in aluminium
- 2 flute design improves chip evacuation at 14.0 mm diameter
- Necked profile allows deeper cavity reach without interference
- California Proposition 65 warning for cancer risk
- California Proposition 65 warning for reproductive harm risk
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What does the 14.0 mm diameter mean when the end mill is cutting in a CNC machine?
The 14.0 mm cutting diameter removes a 14.0 mm wide path per pass, determining the stepover and material removal rate for slotting or profiling operations.
What shank interface does the 13555122N use and what does that standard cap in practice?
The tool uses a standard cylindrical shank for collet or end-mill holders; the shank diameter matches the 14.0 mm cutting diameter, so it fits 14.0 mm ER collets or Weldon flats directly.
What physical clearance does the necked design need to fit inside a fixture or workpiece?
The necked portion provides a reduced diameter behind the flutes, allowing the tool to reach deeper cavities without the shank or holder contacting the workpiece walls.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
