M.A. Ford
M.A. Ford 13555122 End Mill 14.0 mm
TuffCut AL two-flute end mill, 14.0 mm diameter, for aluminium machining
- TypeCutting Tools
- Two-flute design clears chips efficiently in aluminium
- 0 mm cutting diameter suits medium milling tasks
- TuffCut Al geometry optimised for non-ferrous materials
- New condition ensures full factory performance
- California Proposition 65 warning notes chemical hazards
M.A. Ford 14.0 mm End Mill
The M.A. Ford 13555122 is a TuffCut AL two-flute end mill with a 14.0 mm cutting diameter. It is manufactured for machining aluminium and other non-ferrous materials. This cutting tool suits CNC operators and metalwork shops that need a dedicated aluminium geometry.
Two-flute geometry limits chip evacuation
The two-flute design provides large flute valleys for effective chip evacuation in aluminium. However, the reduced flute count limits feed rates compared to tools with higher flute counts. It is not suited for high-efficiency roughing strategies that demand three or more flutes. The geometry is optimised for non-ferrous alloys rather than steel or titanium.
14.0 mm diameter defines the cut width
The 14.0 mm cutting diameter determines the slot width and step-over capability in a single pass. Select this tool only when the programmed feature matches this specific diameter. A different diameter is required for any other finished dimension.
Highlights
- Two-flute design clears chips efficiently in aluminium
- 0 mm cutting diameter suits medium milling tasks
- TuffCut Al geometry optimised for non-ferrous materials
- New condition ensures full factory performance
- California Proposition 65 warning notes chemical hazards
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Is the 14.0 mm diameter the right size for my milling job?
Choose the 14.0 mm end mill when your operation requires that exact cutting diameter; the tool is a two-flute design intended for aluminium and similar non-ferrous materials.
What does the two-flute design mean for chip removal in aluminium?
Two wide flutes give large chip space so aluminium curls evacuate quickly, reducing re-cutting and leaving a cleaner finish at higher feed rates.
How does the shank interface affect tool holding and run-out?
The cutter uses a standard cylindrical shank that fits ER collets, Weldon flats or hydraulic holders; precision grinding keeps run-out low for accurate slot and profile cuts.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
