M.A. Ford
M.A. Ford 13547240N End Mill 12.0mm
Two-flute necked end mill with 12.0 mm diameter for aluminium machining
- TypeCutting Tools
- TuffCut AL coating optimises aluminium cutting
- Two-flute geometry clears chips in soft metals
- Necked profile reaches deep cavities without interference
- 0 mm diameter suits standard tool holders
- California Proposition 65 warning informs safe handling
12.0 mm Two-Flute End Mill
This M.A. Ford 13547240N Tuffcut Al end mill has a 12.0 mm cutting diameter and a necked, two-flute design. It is built for aluminium and other non-ferrous metals. Machinists and CNC operators use it for high-speed slotting and profiling jobs.
Aluminium machining specialists
The tool suits shops cutting aluminium, brass or plastic where chip evacuation matters. It is not for hardened steels, exotic alloys or operations that demand a higher flute count for finish passes. Buyers who need a different diameter or a coated variant should look at other listings.
12.0 mm cutting diameter
The 12.0 mm diameter is the single figure that decides fit for your holder and toolpath. Orders of $75 or more ship free from the manufacturer. A California Proposition 65 notice applies because the product contains a listed chemical.
Highlights
- TuffCut AL coating optimises aluminium cutting
- Two-flute geometry clears chips in soft metals
- Necked profile reaches deep cavities without interference
- 0 mm diameter suits standard tool holders
- California Proposition 65 warning informs safe handling
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter does the 12.0 mm end mill need to fit my tool holder?
The cutter has a 12.0 mm diameter, so select a collet or holder that matches that shank size.
How do I install the necked 2-flute end mill without damaging the flutes?
Clamp on the shank only, keep the necked section clear of the holder, and tighten evenly to avoid run-out.
When should I replace this Tuffcut Al end mill?
Replace it when the cutting edges show visible wear, chipping, or when surface finish on aluminium degrades.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
