M.A. Ford
M.A. Ford 13547209N3 12.0 mm End Mill
12.0 mm two-flute necked end mill for aluminium machining, model 13547209N3
- TypeCutting Tools
- Two-flute geometry clears chips efficiently in aluminium
- Necked design reaches deep cavities without interference
- 0 mm cutting diameter suits medium milling tasks
- TuffCut Al coating resists built-up edge on non-ferrous metals
- M.A. Ford manufacture ensures consistent tool tolerance
What this tool is
The M.A. Ford 13547209N3 is a 12.0 mm necked end mill with two flutes from the Tuffcut Al range. It is made for milling aluminium and similar non-ferrous materials in a workshop or light-production setting.
Heat and power in use
The necked profile gives extra reach so the shank clears deep pockets without rubbing the wall. Two flutes move chips quickly in soft alloys, keeping the cutting zone cooler and reducing the load on the spindle motor.
Build and daily fit
Solid carbide construction holds an edge longer than high-speed steel when run at recommended speeds. The plain cylindrical shank fits standard ER collets or Weldon holders, so the tool drops into existing tooling without adapters.
Highlights
- Two-flute geometry clears chips efficiently in aluminium
- Necked design reaches deep cavities without interference
- 0 mm cutting diameter suits medium milling tasks
- TuffCut Al coating resists built-up edge on non-ferrous metals
- M.A. Ford manufacture ensures consistent tool tolerance
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
How is the 12.0 mm necked end mill installed in a tool holder, and which step is most often missed?
Clamp the shank fully into a matching collet or holder, then verify the necked section clears the workpiece before tightening — skipping the clearance check causes collisions.
What maintenance or replacement will the 2 flute Tuffcut Al end mill need after extended use?
The cutting edges will dull and require resharpening or replacement; inspect flutes regularly for wear or chipping that degrades finish quality.
What limit appears first on the 12.0 mm aluminium end mill during sustained high-speed milling?
Heat buildup in the flutes reduces edge life and can cause premature wear or workpiece surface degradation if feed and speed are not balanced.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
