M.A. Ford
M.A. Ford 13539305N3 End Mill 10.0Mm
A 10.0 mm necked two-flute end mill for aluminium cutting applications
- TypeCutting Tools
- 2-flute geometry optimised for aluminium machining
- Necked design provides extended reach in deep cavities
- 0 mm cutting diameter suits standard milling operations
- TuffCut Al coating reduces built-up edge on soft alloys
- California Proposition 65 chemical warning applies to this item
M.A. Ford 10.0 mm End Mill
The M.A. Ford 13539305N3 is a Tuffcut Al two-flute end mill with a necked design and a 10.0 mm diameter. It is a cutting tool manufactured by M.A. FORD for precision milling tasks. The product is supplied new and ships directly from the manufacturer. It carries California Proposition 65 warnings regarding cancer and reproductive harm.
For Aluminium Milling Specialists
This tool suits machinists and fabricators milling aluminium and non-ferrous alloys where a necked profile provides extra reach. It is not for buyers who need higher flute counts for finishing passes or different diameter sizes. It is not for general-purpose steel cutting without verifying compatibility. Orders of $75 or more ship free.
10.0 mm Cutting Diameter Decides Fit
The 10.0 mm cutting diameter is the single specification that determines whether this end mill fits the required tool holder and matches the programmed tool path. Verify this exact dimension against your CAD/CAM setup and machine capacity before purchase. The necked geometry and two-flute design support chip evacuation in deep slots.
Highlights
- 2-flute geometry optimised for aluminium machining
- Necked design provides extended reach in deep cavities
- 0 mm cutting diameter suits standard milling operations
- TuffCut Al coating reduces built-up edge on soft alloys
- California Proposition 65 chemical warning applies to this item
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What does the California Proposition 65 warning on the M.A. Ford 13539305N3 end mill indicate?
The warning states the product contains a chemical known to the State of California to cause cancer and birth defects or other reproductive harm.
What shank diameter must a tool holder accommodate for this 10.0 mm necked end mill?
The tool has a 10.0 mm cutting diameter, so the holder must accept a 10.0 mm shank for proper clamping.
How should the two-flute necked end mill be secured in a collet to avoid runout?
Insert the shank fully into a clean, matched 10.0 mm collet and tighten the collet nut to the manufacturer's torque specification.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
