M.A. Ford
M.A. Ford 13539304N5 End Mill 10.0mm
A necked two-flute end mill for aluminium, 10.0 mm diameter, new condition
- TypeCutting Tools
- Tuffcut Al coating reduces aluminium adhesion
- Two-flute geometry clears chips efficiently in soft alloys
- Necked shank provides reach for deep pockets
- 0 mm cutting diameter suits standard milling tasks
- California Proposition 65 warning discloses regulated substances
M.A. Ford 10.0mm Neck End Mill
This M.A. Ford 13539304N5 Tuffcut Al end mill has a 10.0mm cutting diameter and a necked, two-flute design. It is made for machinists who need extended reach in deep pockets or cavities. The tool suits aluminium and non-ferrous milling where chip evacuation matters.
Replaces shorter reach cutters
A necked end mill replaces a standard flute-length tool when the workpiece depth exceeds the normal cutting length. The jump is worth it when you must machine deep features without rubbing the shank against the wall. Buyers who only mill shallow profiles will not need the extra reach.
Limited by flute count and material focus
Two flutes restrict feed rates in harder alloys and limit chip load per revolution compared with higher-flute tools. The geometry is optimised for aluminium, so steel or titanium cutting will wear the edges faster. Users needing high-speed finishing in tough metals should select a different flute configuration.
Highlights
- Tuffcut Al coating reduces aluminium adhesion
- Two-flute geometry clears chips efficiently in soft alloys
- Necked shank provides reach for deep pockets
- 0 mm cutting diameter suits standard milling tasks
- California Proposition 65 warning discloses regulated substances
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What tool holder or collet size fits the 10.0 mm shank of this end mill?
Use a 10.0 mm collet or shrink-fit holder that matches the shank diameter exactly.
What is the correct tightening sequence when clamping this necked end mill in a holder?
Clean the shank and holder bore, insert the tool to the recommended depth, then torque the collet nut to the holder manufacturer's specification.
When should the 13539304N5 be replaced during production runs?
Replace the tool when flank wear reaches the shop's wear limit or when burrs appear on the finished edge.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
