M.A. Ford
M.A. Ford 13539301N5 End Mill 10.0mm
A 10.0 mm diameter, two-flute necked end mill designed for aluminium machining tasks
- TypeCutting Tools
- 0 mm diameter suits precise aluminium milling
- Two-flute geometry clears chips efficiently in soft metals
- Necked design reaches deep cavities without deflection
- TuffCut Al coating resists built-up edge on aluminium
- California Proposition 65 warning lists cancer and reproductive-harm chemicals
10.0 mm TuffCut AL End Mill
The M.A. Ford 13539301N5 is a two-flute necked end mill with a 10.0 mm cutting diameter designed for aluminium machining. It belongs to the TuffCut AL range built for high material-removal rates in non-ferrous workpieces. The tool is supplied new and ships directly from the manufacturer.
Machinists cutting aluminium
This cutter suits CNC operators and job-shop machinists who need a dedicated aluminium tool with a necked profile for deeper pocket access. It is not intended for steel, stainless steel, titanium or hardened alloys where a different substrate and coating are required. Woodworkers and general-purpose fabricators should select a geometry optimised for those materials.
Two-flute necked geometry
The defining specification is the two-flute necked design combined with a 10.0 mm diameter, which governs chip evacuation and reach in aluminium pockets. Buyers must verify that their holder and machine spindle accept this shank configuration before ordering.
Highlights
- 0 mm diameter suits precise aluminium milling
- Two-flute geometry clears chips efficiently in soft metals
- Necked design reaches deep cavities without deflection
- TuffCut Al coating resists built-up edge on aluminium
- California Proposition 65 warning lists cancer and reproductive-harm chemicals
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What milling machine spindle or tool holder is required to run a 10.0 mm shank end mill?
You need a milling machine or CNC spindle that accepts a 10.0 mm shank, typically via an ER collet, shrink-fit holder or Weldon flat holder matched to that diameter.
Can this two-flute necked cutter be used effectively on older manual knee mills as well as modern CNC centres?
Yes, the 2-flute geometry and necked reach suit both manual and CNC machines; simply choose conservative speeds and feeds for the rigidity of the older mill.
How can I verify the TuffCut AL 13539301N5 is cutting cleanly in aluminium after the first pass?
Look for bright, continuous chips, a smooth wall finish without built-up edge, and dimensional accuracy within your tolerance on the finished pocket or profile.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
