M.A. Ford
M.A. Ford 13525001 Garden Statue
A two-flute necked end mill for aluminium milling, supplied new from M.A. Ford
- TypeCutting Tools
- Precision aluminium milling with 2-flute TuffCut geometry
- Neck-relief design clears chips in deep cavities
- 1/4 in shank fits standard collets
- California Prop 65 chemical warning disclosed
- Manufacturer direct shipping on orders over $75
M.A. Ford 13525001 End Mill
The M.A. Ford 13525001 is a two-flute necked end mill designed for aluminium machining. It is supplied new and intended for milling operations that require extended reach in non-ferrous materials. The tool carries the Tuffcut Al designation for aluminium-specific geometry. California Proposition 65 warnings apply to this product.
Machinists needing aluminium reach
This tool suits CNC operators and manual machinists cutting aluminium where a necked shank provides clearance for deep pockets or tall walls. It is not for buyers who need a different flute count, a different cutting diameter, or a tool optimised for steel, titanium or composite materials. The Proposition 65 notice may also deter users who require materials without listed chemical hazards.
1/4 inch cutting diameter
The 1/4 inch cutting diameter is the primary specification that determines whether this end mill matches the programmed tool path and workpiece requirements. Verify this dimension against your CAM setup and fixture constraints before ordering. No other diameter options are described for this part number.
Highlights
- Precision aluminium milling with 2-flute TuffCut geometry
- Neck-relief design clears chips in deep cavities
- 1/4 in shank fits standard collets
- California Prop 65 chemical warning disclosed
- Manufacturer direct shipping on orders over $75
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
Does the M.A. Ford 13525001 end mill generate much heat or noise during long machining runs?
The solid-carbide TuffCut AL 2-flute geometry is designed for aluminium, so chips evacuate quickly and cutting temperatures stay lower than with general-purpose tools.
What holder or collet do I need to run this 1/4-inch necked end mill?
A standard 1/4-inch ER collet, Weldon flat holder or shrink-fit chuck that accepts a 1/4-inch shank will secure it.
Will this necked cutter reach deep pockets on my older manual knee mill?
The necked profile provides extra clearance for deep cavities, and the 2-flute design works well at the lower spindle speeds typical of older machines.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
