M.A. Ford
M.A. Ford 13523605N3 End Mill Necked 6.0Mm
A two-flute necked end mill with a 6.0 mm diameter for aluminium machining
- TypeCutting Tools
- Precision necked design for deep-pocket milling
- Two-flute geometry clears chips in aluminium
- 0 mm cutting diameter matches standard tooling
- California Prop 65 warning informs safe handling
- Ships direct from M.A. Ford for factory-fresh condition
M.A. Ford 6.0 mm Necked End Mill
The M.A. Ford 13523605N3 is a new Tuffcut Al two-flute end mill with a 6.0 mm diameter and a necked profile. It is a cutting tool intended for aluminium milling where extended reach and chip clearance are required.
For aluminium milling with reach needs
Machinists who need a necked geometry for deep pockets or thin walls in aluminium will suit this tool. Buyers who require more flutes, a different coating or a non-necked design should look at something else.
Fits standard 6.0 mm tool holders
The shank matches common 6.0 mm collets and holders so no special clamping is needed. The necked section frees clearance for deeper features without increasing overall tool length.
Highlights
- Precision necked design for deep-pocket milling
- Two-flute geometry clears chips in aluminium
- 0 mm cutting diameter matches standard tooling
- California Prop 65 warning informs safe handling
- Ships direct from M.A. Ford for factory-fresh condition
Specifications
| Brand | M.A. FORD |
|---|---|
| Type | Cutting Tools |
Questions about this item
What shank diameter collet or holder do I need for the 6.0 mm necked end mill?
The cutter has a 6.0 mm shank, so use a 6 mm ER collet, shrink-fit holder or hydraulic chuck with a matching 6 mm bore.
Will the two-flute geometry work on my older manual knee mill?
Yes, the two-flute design runs on any mill with a 6 mm tool holder, including manual machines, though feed rates will be lower than on CNC.
How can I confirm the necked profile is cutting correctly after the first pass?
Measure the stepped diameter behind the flutes; it should match the neck relief shown in the tool drawing and leave no witness marks on the wall.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
