M.A. Ford
M.A. Ford 13.50 mm Cyclone XD 5X Solid Double Margin Drill 1350AP
13.50 mm solid double-margin drill delivers five-times-diameter reach for deep-hole drilling
- 50 mm diameter fits precise hole requirements
- Cyclone XD design supports 5X drilling performance
- Solid double margin construction improves hole accuracy
- M.A. Ford manufacturing delivers professional-grade tool quality
- California Proposition 65 compliance ensures regulated chemical disclosure
Cyclone XD 5X 13.50 mm Drill
The M.A. Ford Cyclone XD 5X is a solid double margin drill with a 13.50 mm cutting diameter. It is built for precision holemaking in demanding materials. Machinists and maintenance teams use it where hole accuracy and tool life are critical. The solid carbide construction supports rigid setups in CNC and manual operations.
Sustained-load behaviour
The double margin design stabilises the drill during deep cuts and prolonged cycles. It resists deflection and maintains diameter consistency across repeated hits. Heat distributes evenly through the solid body, reducing edge breakdown under continuous feed. Chip evacuation stays reliable without Pecking interruptions.
Upgrade path
This drill replaces single-margin or coated high-speed steel tools that wander in tough alloys. The jump is worth it when scrap rates climb from oversize holes or premature wear. Shops running 1350-series diameters in stainless, titanium or hardened steel see longer intervals between tool changes. It does not suit low-rigidity portable drilling or large-diameter roughing.
Highlights
- 50 mm diameter fits precise hole requirements
- Cyclone XD design supports 5X drilling performance
- Solid double margin construction improves hole accuracy
- M.A. Ford manufacturing delivers professional-grade tool quality
- California Proposition 65 compliance ensures regulated chemical disclosure
Specifications
| Brand | M.A. FORD |
|---|
Questions about this item
How much heat does the 13.50 mm Cyclone XD 5X drill generate during continuous drilling?
The solid double-margin design improves chip evacuation, which reduces friction and heat build-up during extended drilling cycles.
What tool holder or machine spindle is required to run the 1350AP drill?
A standard drill chuck or collet that accepts a 13.50 mm shank is needed; the drill has no proprietary mounting system.
Will the 13.50 mm Cyclone XD 5X work with an older pillar drill that has lower spindle speed?
The geometry is optimised for higher speeds but still cuts in conventional machines; reduce feed rate to match the lower RPM.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
