Lumitec Inc
Lumitec Scallop Surface Mount Pathway Light Spectrum RGBW Warm White Stainless Steel Housing marine electronic
A low-profile, surface-mount pathway light offering warm white or full-colour RGBW output from a hand-polished 316 stainless steel housing
- TypeAccessories
- ADA-compliant low-glare beam for safe walkways
- 316 stainless housing withstands marine corrosion
- RGBW plus warm white colour options
- IP67 sealed for full water protection
- PLI and TTP control works with 12-24V DC power
Purpose-built marine pathway light
The Lumitec Scallop is a surface-mounted fixture designed for docks and walkways. Its low-profile housing meets ADA requirements and carries an IP67 rating for full water sealing. The unit operates on any 10-30V DC supply and draws 4 watts.
Suited for permanent deck or dock installs
Boat owners wanting colour-changing RGBW output or a steady warm white glow will find both modes in one housing. The PLI and TTP compatibility lets it join a Mantis kit or a Kraken system. Builders who need a recessed or through-hull fitting should look at a different form factor.
316 stainless housing with 4-inch diameter
The 0.60-inch thick disc mounts with two supplied screws and handles 340mA at 12V or 190mA at 24V. The engineered beam angle lights walking surfaces without glare. No control module is included, so a separate POCO-compatible controller is required for colour changes.
Highlights
- ADA-compliant low-glare beam for safe walkways
- 316 stainless housing withstands marine corrosion
- RGBW plus warm white colour options
- IP67 sealed for full water protection
- PLI and TTP control works with 12-24V DC power
Specifications
| Type | Accessories |
|---|
Questions about this item
Does this pathway light need a separate 12 V or 24 V DC power supply to operate?
Yes, it runs on any standard 10–30 V DC supply, drawing 340 mA at 12 V or 190 mA at 24 V.
Can I add this Scallop light to my existing Mantis dock light kit without extra wiring changes?
The unit is PLI and TTP enabled, so it connects directly to a Mantis dock light kit using the same low-voltage circuit.
How do I confirm the IP67 seal is intact after I mount the light?
Power the light and cycle through the RGBW colours and warm white mode; consistent output across all modes shows the water seal is holding.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
Taylor 70204 Acrylic Coated Polyester Gray Hot Shot BoatGuard Boat Cover
- Transparent
BoatBuckle F12071 Kwik-Lok Gunwale Tie-Down Stainless Steel
- Transparent



