We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two small green circuit boards with black USB Type-E connectors, vertical orientation

LORDWORLD

LORDWORLD USB 3.0 to 3.1 Gen 2 Header Adapter 2 Pack 19/20 Pin to 20 Pin Type-E

SKU CH-1RRM-QKYNW

Converts motherboard 19-pin or 20-pin USB 3.0 headers to a 20-pin USB 3.1 Gen 2 Type-E port supporting up to 10 Gbps, supplied as a two-pack

  • Converts 19 or 20 pin USB 3.0 headers to 20 pin USB 3.1 Gen 2 Type-E
  • Vertical low-profile design fits tight spaces without blocking nearby components
  • Multi-layer PCB with differential signal optimisation delivers stable 10 Gbps data paths
  • Works with most motherboard USB 3.0 and 3.1 19 pin headers for broad compatibility
  • Two adapters included so you can upgrade multiple front-panel ports at once

Front-panel USB 3.1 Gen 2 upgrade

This two-pack adapter converts a motherboard USB 3.0 19-pin or 20-pin header into a 20-pin USB 3.1 Gen 2 Type-E connector. It lets cases with a front-panel USB 3.1 Gen 2 port run at the newer standard even when the board only provides a USB 3.0 header. The vertical, low-profile design fits tight spaces without blocking nearby components.

Sustained signal integrity

Multi-layer PCB construction with integrated differential signal optimisation maintains stable throughput during long file transfers or continuous device use. The layout suppresses crosstalk and electromagnetic interference that can degrade performance over time. Actual transfer rates remain dependent on the connected peripheral and cable quality.

USB 3.1 Gen 2 Type-E practical limits

The Type-E interface is rated for up to 10 Gbps, but real-world speed is capped by the slowest link in the chain — motherboard header, adapter, cable or device. The adapter only bridges the physical connector; it cannot raise the electrical signalling beyond what the source header delivers. Compatibility covers most boards with a 19-pin USB 3.0/3.1 header.

Highlights

  • Converts 19 or 20 pin USB 3.0 headers to 20 pin USB 3.1 Gen 2 Type-E
  • Vertical low-profile design fits tight spaces without blocking nearby components
  • Multi-layer PCB with differential signal optimisation delivers stable 10 Gbps data paths
  • Works with most motherboard USB 3.0 and 3.1 19 pin headers for broad compatibility
  • Two adapters included so you can upgrade multiple front-panel ports at once

Specifications

BrandLORDWORLD

Questions about this item

Does the adapter draw extra power or generate noticeable heat when running all day?

It is a passive header adapter with no active circuitry, so it adds no measurable power draw or heat during continuous operation.

What must my motherboard already have for these adapters to work?

A free USB 3.0 19-pin or 20-pin internal header on the motherboard is required to plug the adapter in.

Will the 10 Gbps Type-E port work properly with my older USB 3.0 front-panel ports?

The adapter converts the motherboard header to a 20-pin Type-E connector; any device attached will negotiate down to USB 3.0 speeds if the front-panel port or cable is only USB 3.0.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.