We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Flat 40mm PCIe flexible cable, 8.52mm wide, for Raspberry Pi 5

LORDWORLD

LORDWORLD PCIe Flexible Cable 40mm for Raspberry Pi 5

SKU CH-F1SG-JPYC9

A 40 mm flexible PCIe cable for Raspberry Pi 5, compatible with multiple M.2 HAT boards

  • Connect Raspberry Pi 5 PCIe HATs with a compact 40 mm flex cable
  • 52 mm wide ribbon fits tight enclosure spaces without strain
  • Supports WaveShare 2-CH M.2, ETH M.2 and M.2 Board (D) HATs
  • Ready-to-use single cable eliminates custom wiring effort
  • New condition guarantees reliable signal integrity from first use

PCIe Flexible Cable for Raspberry Pi 5

This 40 mm cable connects a Raspberry Pi 5 to compatible PCIe HATs. It suits makers and developers who need a short, pliable link between the board and an expansion module. The flexible construction allows tight routing inside compact enclosures. It is not intended for longer runs or for connecting devices outside the immediate chassis.

40 mm length and 8.52 mm width

The cable measures 40 mm end to end and 8.52 mm across, so it only fits setups where the HAT sits directly beside the Pi. If your mounting points are further apart, this cable will not reach. Check the exact spacing of your HAT before ordering.

Connects one PCIe HAT at a time

The package contains a single cable, which carries one PCIe lane to a supported HAT such as a dual M.2 or Ethernet add-on. It does not split the bus, so only one HAT can be used per cable. Builders needing multiple simultaneous HATs must source additional cables and verify the Pi can drive them.

Highlights

  • Connect Raspberry Pi 5 PCIe HATs with a compact 40 mm flex cable
  • 52 mm wide ribbon fits tight enclosure spaces without strain
  • Supports WaveShare 2-CH M.2, ETH M.2 and M.2 Board (D) HATs
  • Ready-to-use single cable eliminates custom wiring effort
  • New condition guarantees reliable signal integrity from first use

Specifications

BrandLORDWORLD

Questions about this item

What does the 40 mm length mean once the cable is installed in a Raspberry Pi 5?

The 40 mm flexible cable connects the Pi 5 PCIe FPC connector to a compatible HAT, allowing the HAT to sit close to the board while maintaining signal integrity.

Which interface standard does the cable carry and what does that limit in practice?

It carries the Raspberry Pi 5 PCIe Gen 2 ×1 lane, so the link tops out at 5 GT/s and one lane of bandwidth for any attached M.2 or Ethernet HAT.

What physical space does the cable need to fit and mount?

The cable measures 40 mm long by 8.52 mm wide, so it needs a straight 40 mm run between the Pi 5 FPC port and the HAT connector with at least 8.52 mm clearance.

New to this? Buying PC parts with Monero — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.