We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
A flexible 10 cm PCIe 1x riser ribbon with a 90-degree angled connector and an auxiliary power cable

LORDWORLD

LORDWORLD PCIe 1X Riser Extender 10cm 90 Degree Angled

SKU CH-JBZF-4CY6S

A flexible 10 cm PCIe 1x riser with a 90-degree angled connector relocates expansion cards in tight or low-profile chassis and includes an auxiliary power cable

  • 90-degree angled connector fits tight spaces around the motherboard
  • 10 cm flexible ribbon cable relocates a PCIe x1 card away from the board
  • Additional power cable supplies stable current to the relocated card
  • No driver installation required for immediate use
  • Designed for custom enclosures and low-profile rack-mount chassis

Compact PCIe 1x riser for tight builds

The LORDWORLD PCIe 1X riser extender moves a single-lane card away from the motherboard using a 10 cm flexible ribbon. A 90 degree angled connector lets the slot face away from the board even when clearance around the header is minimal. An auxiliary power lead is included to reinforce delivery to the relocated device. It requires no driver and does not support hot-swap operation.

Suited for custom enclosures and low-profile racks

Builders fitting expansion cards into shallow chassis or custom brackets will benefit from the angled, flexible routing. The short 10 cm length limits how far the card can be displaced, so projects that need longer reach should look at alternative risers. The lack of hot-swap support also means the host must be powered down before inserting or removing cards.

10 cm ribbon length decides fit

The fixed 10 cm flex cable determines the maximum distance between the motherboard slot and the relocated card. Measure the required path inside your enclosure before purchase; if the route exceeds this length the riser cannot be used.

Highlights

  • 90-degree angled connector fits tight spaces around the motherboard
  • 10 cm flexible ribbon cable relocates a PCIe x1 card away from the board
  • Additional power cable supplies stable current to the relocated card
  • No driver installation required for immediate use
  • Designed for custom enclosures and low-profile rack-mount chassis

Specifications

BrandLORDWORLD

Questions about this item

How do I install the 90 degree angled riser without shorting the board?

Plug the male edge connector into the motherboard PCIe 1x slot, route the 10 cm flex ribbon to an EMI-safe mounting point, secure the expansion card firmly so it cannot flex back onto the board, then attach the supplementary power cable before powering on.

What upkeep does the 10 cm flex ribbon need over time?

Inspect the ribbon and both connectors periodically for dust, kinks or cracked traces; reseat the card and clean contacts with isopropyl alcohol if signal errors appear, otherwise no scheduled maintenance is required.

At what point does the 90 degree connector become the limiting factor during sustained loads?

The right-angle header is rated for the standard PCIe 1x power envelope; prolonged draws near that ceiling can heat the connector first, so monitor connector temperature if the attached card runs continuously at high utilisation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.