LORDWORLD
LORDWORLD Nema L5-30R 30A 125V 2-Pack Twist-Lock Connector
Two ETL-certified twist-lock connectors rated 30 A at 125 V accept cords from AWG 10 to 18 and feature nylon housings with brass terminals
- ETL certified for USA and Canada safety compliance
- 30 A 125 V rating supports high-power equipment
- Twist-lock screw design prevents accidental disconnection
- Accepts cables from 18 AWG up to 10 AWG
- 94V-0 nylon housing resists flame and heat
LORDWORLD Nema L5-30R Connector 2-Pack
This two-pack supplies ETL-certified NEMA L5-30R female receptacles rated for 30 amps at 125 volts AC. Each unit features a twist-lock design with solid nylon housing and brass terminals for secure industrial-grade connections. The connectors accept cable sizes from AWG 10 through AWG 18 for versatile DIY wiring.
Suits 30A 125V twist-lock needs.
These receptacles match equipment requiring a NEMA L5-30R locking interface at 30 amps and 125 volts. They are unsuitable for circuits demanding higher current ratings or different voltage configurations. Builders needing alternative pin arrangements or non-locking plugs should select a different connector type.
ETL-certified 30A 125V NEMA L5-30R rating
The single specification that determines compatibility is the NEMA L5-30R designation rated at 30 amps and 125 volts AC. This defines the exact locking geometry and electrical capacity required by the mating inlet. Verify your equipment specifies this NEMA code before purchase.
Highlights
- ETL certified for USA and Canada safety compliance
- 30 A 125 V rating supports high-power equipment
- Twist-lock screw design prevents accidental disconnection
- Accepts cables from 18 AWG up to 10 AWG
- 94V-0 nylon housing resists flame and heat
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
What does the NEMA L5-30R rating cap at in practice?
The connector is rated for 30 amps at 125 volts AC, 60 Hz, with a vertical flame rating of 94V-0.
What cable sizes does the strain relief accept?
The solid strain relief fits cables from AWG 18 up to AWG 10, covering SJT and STW types.
How do you wire the three terminals, and what mistake should be avoided?
The three brass terminals are screw-lock type; strip each conductor to the correct length and tighten every screw fully so no loose strands remain.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
