We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Low-profile right-angled USB 3.0 cable with 20-pin male and 19-pin female connectors, 24cm length

LORDWORLD

LORDWORLD Low Profile Right Angled USB 3.0 20Pin 19Pin Male Female Extension Cable 24cm

SKU CH-D7TX-TNGYT

Low-profile right-angled extension connects 19-pin or 20-pin USB 3.0 motherboard headers at up to 5 Gbps over 24 cm

  • Low-profile right-angled design saves space in tight builds
  • 24 cm length fits compact motherboard layouts without excess cable
  • USB 3.0 compliance delivers up to 5 Gbps throughput with compatible host and device
  • Male-to-female 20-pin/19-pin connector plugs directly into any USB 3.0 header
  • Supports simultaneous two-way data transmission for reliable front-panel USB performance

Compact 24cm USB 3.0 Header Extension

This 24cm right-angled cable connects a 19-pin or 20-pin USB 3.0 motherboard header to a female port. It supports the USB 3.0 specification and delivers up to 5Gbps throughput when paired with a USB 3.0 host and device. The low-profile angled design saves space inside tight chassis and requires no extra adapters for installation. The key position on the header determines the cable direction.

Builders with cramped front-panel headers

The short length and right-angle plug suit small-form-factor cases where a straight cable would block other components. It works with standard 19-pin and 20-pin USB 3.0 headers found on many desktop mainboards. Builders needing a longer reach or a straight connector for rear-panel routing should look at a different cable. Systems without a USB 3.0 header cannot use this adapter.

Fits directly onto the motherboard header

The male end plugs straight into the board’s 19-pin or 20-pin USB 3.0 header without brackets or screws. The female end accepts a standard USB 3.0 front-panel or accessory cable. By bending close to the board, the cable frees up clearance around the header area for power cables or cooling ducts. No external power or drivers are required for operation.

Highlights

  • Low-profile right-angled design saves space in tight builds
  • 24 cm length fits compact motherboard layouts without excess cable
  • USB 3.0 compliance delivers up to 5 Gbps throughput with compatible host and device
  • Male-to-female 20-pin/19-pin connector plugs directly into any USB 3.0 header
  • Supports simultaneous two-way data transmission for reliable front-panel USB performance

Specifications

BrandLORDWORLD

Questions about this item

What motherboard header does the 20-pin male end need to plug into?

It fits a standard 20-pin or 19-pin USB 3.0 header on the motherboard.

Will the right-angled connector clear a graphics card that sits close to the USB 3.0 header?

The low-profile angled design saves space and eases bending, helping it fit beside tall components.

How can I confirm the cable is delivering 5 Gbps after installation?

Connect a USB 3.0 device and verify the OS reports SuperSpeed operation at up to 5 Gbps.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.