LORDWORLD
LORDWORLD DC 12V to 24V Step-Up Converter 15A 360W IP67 Waterproof
Converts DC 12V to 24V at 15A with over 96% efficiency, IP67 waterproof and shockproof housing, and built-in protection against over-voltage, under-voltage, overload, over-heat and short circuit
- Converts 12V to 24V for vehicle and solar use
- Over 96% conversion efficiency reduces energy waste
- IP67 waterproof and shockproof housing suits outdoor installations
- Built-in over-voltage, under-voltage, overload, over-heat and short-circuit protection
- Compact 12 cm cable allows easy fitting in tight spaces
12V to 24V Step-Up Converter 15A 360W
This DC-DC step-up converter accepts an input range of 9 to 20 volts and delivers a regulated 24-volt output at up to 15 amps. It suits vehicle, marine and off-grid systems that need to run 24-volt loads from a 12-volt source.
IP67 Waterproof Housing 12cm Leads
The unit is potted with heat-conductive silica gel to meet IP67 waterproof and shockproof ratings, and the 12-centimetre flying leads keep wiring tidy in tight compartments. Installation is straightforward: connect input to the source, output to the load, and secure the compact case. Reverse polarity or sustained overload will trigger the built-in protections and shut the converter down.
Check Input Voltage and Load Current
Verify that your source stays within the 9 to 20 volt window under all operating conditions and that the total 24-volt load does not exceed 15 amps. Systems requiring higher current or a different output voltage will need a different converter.
Highlights
- Converts 12V to 24V for vehicle and solar use
- Over 96% conversion efficiency reduces energy waste
- IP67 waterproof and shockproof housing suits outdoor installations
- Built-in over-voltage, under-voltage, overload, over-heat and short-circuit protection
- Compact 12 cm cable allows easy fitting in tight spaces
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
How can I confirm the converter is delivering 24V after installation?
Measure the output terminals with a multimeter under load; a steady reading at 24V and the connected device operating normally shows the unit is working as intended.
What comes in the box and what must I supply myself?
The converter with its 12 cm leads is included; you must provide a 12V source within the 9-20V input range and suitable connectors for your load.
Which version should I choose for a 360W maximum load?
This single 15A 360W model covers the full 9-20V input range and 24V output, so no other capacity version is needed for that power level.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



