We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Rectangular aluminium M.2 2280 heatsink with ARGB mirror centre, 72 by 23 by 14 mm, thermal pads included

LORDWORLD

LORDWORLD ARGB M.2 2280 Heatsink with Thermal Pads

SKU CH-EQ7W-RYPG8

Aluminium heatsink with thermal pads cools M.2 2280 NVME SSDs and adds 5 V 3-pin ARGB lighting with mirror reflection

  • Prevents thermal throttling with aluminium heatsink for 2280 SSDs
  • Synchronises RGB lighting via 5V 3-pin motherboard header
  • Includes three thermal pads sized 70x20x1mm for full coverage
  • Compact 72x23x14mm design fits tight M.2 slots
  • Mirror-reflection centre panel creates multi-layer lighting effects

ARGB M.2 2280 heatsink

The LORDWORLD ARGB M.2 2280 heatsink is an aluminum cooler designed for M.2 2280 NVMe SSDs. It addresses thermal throttling by dissipating heat through the aluminum body and included thermal pads. Integrated 5V 3-pin addressable RGB lighting adds synchronised illumination to the build. It suits enthusiasts wanting both temperature control and visual customisation.

Upgrade from bare-drive operation

This heatsink replaces the stock motherboard shield or bare-drive operation when an SSD runs hot enough to throttle. The aluminium construction and 70x20x1mm thermal pads transfer heat away from the controller and NAND. The jump is worth it when sustained write or read workloads push the drive past its thermal limit, restoring consistent performance.

Build integration

The unit measures 72x23x14mm and requires a 5V 3-pin ARGB header on the motherboard or a compatible controller for lighting control. A 20-inch cable connects the heatsink to the header. Three thermal pads are included for installation. Builders without a 5V ARGB header or with clearance tighter than the stated dimensions cannot use the lighting or fit the cooler.

Highlights

  • Prevents thermal throttling with aluminium heatsink for 2280 SSDs
  • Synchronises RGB lighting via 5V 3-pin motherboard header
  • Includes three thermal pads sized 70x20x1mm for full coverage
  • Compact 72x23x14mm design fits tight M.2 slots
  • Mirror-reflection centre panel creates multi-layer lighting effects

Specifications

BrandLORDWORLD

Questions about this item

Does the 72 mm by 23 mm footprint clear my motherboard heatsinks?

The heatsink measures 72 mm long, 23 mm wide and 14 mm tall, so verify that your board has at least that much clearance around the M.2 2280 slot before fitting it.

How do I attach the 70 mm by 20 mm by 1 mm thermal pads without trapping air bubbles?

Clean the controller and DRAM areas, peel one side of a pad, lay it flat from one edge to the other, then press the heatsink down evenly; the common error is sticking the whole pad at once and creating gaps.

Will the 5 V 3-pin ARGB cable reach the header on a full-size ATX board?

The cable is about 20 inches long, which typically spans from an M.2 slot to a bottom-edge 5 V 3-pin header on ATX boards; route it behind the motherboard tray if the direct path is tight.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.