LORDWORLD
LORDWORLD 90 Degree Up Angle VGA Extension Cable Male to Female 1.5ft
A 1.5 ft VGA extension cable with a 90-degree upward connector for tight spaces, supporting up to 1080p resolution with gold-plated connectors
- Saves space in tight spots with 90-degree up-angle connector
- Extends existing VGA cables 1.5ft for flexible placement
- Supports resolutions up to 1920x1200 and 1080p Full HD
- Gold-plated connectors with strain relief ensure reliable signal transmission
- Thumb screws on male end provide secure, finger-tightened connection
Space-Saving 90 Degree Up-Angle VGA Extension
This 1.5ft VGA male-to-female extension cable uses a 90 degree up-angle connector to fit tight spaces behind monitors, TVs or projectors. Gold-plated contacts and finger-tightened thumbscrews give a secure HD15 link. It suits any device with a standard 15-pin VGA port.
Signal Quality Over the 1.5ft Run
Bare copper conductors carry analogue RGB signals up to 1920x1200 (WUXGA) and 1920x1080 (Full HD) without added latency. Moulded strain relief protects the solder joints when the cable is routed through cable trays or around corners. Supported modes include 800x600, 1024x768 and 1600x1200.
Passive Design Means No Heat or Noise
The cable draws no external power and adds no active circuitry, so it generates zero heat and no audible noise. Power consumption stays at the level of the source graphics output. The flexible jacket resists kinking during repeated connect-disconnect cycles.
Highlights
- Saves space in tight spots with 90-degree up-angle connector
- Extends existing VGA cables 1.5ft for flexible placement
- Supports resolutions up to 1920x1200 and 1080p Full HD
- Gold-plated connectors with strain relief ensure reliable signal transmission
- Thumb screws on male end provide secure, finger-tightened connection
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
Does the 90-degree up-angle connector run hot or draw extra power during all-day use?
The cable is passive with bare copper conductors and gold-plated connectors, so it generates no heat and draws no power of its own during continuous operation.
What existing cable or port must I already have for this 1.5 ft male-to-female extender to work?
You need an existing HD15 VGA cord with a male connector and a device that provides a female VGA 15-pin port, such as a PC, laptop, monitor or projector.
Will this extender work alongside my older 1024x768 XGA monitor without degrading the signal?
Yes, it supports resolutions up to 1920x1200 WUXGA and 1080p, so legacy modes like 1024x768 XGA and 800x600 SVGA pass through with reliable signal transmission.
New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



