LORDWORLD
LORDWORLD 2pcs 24AWG USB 2.0 Pigtail Cable Type A Female to 4Pin Open Cord Latch Mount 10cm
Two USB 2.0 Type-A female pigtail cables with latch mount, 10 cm long, 24 AWG, rated for 480 Mbps data and DC 5 V 3 A power, solder-ready for DIY repair
- Latch-mount design secures USB connections inside cabinets
- Two 10 cm pigtail cables ready for DIY soldering
- USB 2.0 female Type-A delivers 480 Mbps data
- Open 4-pin leads carry DC 5 V up to 3 A
- 24 AWG wires handle both power and data signals
What it is
This pair of USB 2.0 pigtail cables provides a Type-A female socket with a latch-mount flange and four open wires for soldering. Each cable is 10 cm long including the connector and uses 24 AWG conductors. The set is intended for DIY and OEM repair work where a panel-mounted USB port is required.
Deciding specification
The cable supports USB 2.0 signalling at 480 Mbps and can deliver up to DC 5V 3A when mated with a compliant Type-A host and device. Both data and power lines are brought out to the open leads, so the part suits any project that needs a front-panel or enclosure USB 2.0 connection with latch retention.
Thermals noise power
Passive wiring generates no audible noise and adds negligible heat during normal operation. Power handling is limited to the USB 2.0 specification of 5 V at 3 A, so voltage drop across the 10 cm length remains minimal for typical peripheral loads. No active cooling or additional power consideration is needed.
Highlights
- Latch-mount design secures USB connections inside cabinets
- Two 10 cm pigtail cables ready for DIY soldering
- USB 2.0 female Type-A delivers 480 Mbps data
- Open 4-pin leads carry DC 5 V up to 3 A
- 24 AWG wires handle both power and data signals
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
What does the 480 Mbps rating mean once the cable is installed in a device?
The 480 Mbps rating is the maximum USB 2.0 data rate; real-world throughput will be lower and depends on the host controller and connected peripheral.
Which USB standard does the Type-A female socket follow and what does it limit?
The socket follows USB 2.0, capping data at 480 Mbps and power delivery at 5 V 3 A when used with a compatible host and device.
What are the physical requirements for the latch-mount connector to fit in a panel?
The latch-mount connector is designed to snap into a standard panel cut-out; you will need to solder the four open wires to your internal wiring.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



