We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two yellow NEMA 6-50R 50A 250V welder receptacles

LORDWORLD

LORDWORLD 2-Pack NEMA 6-50R 50A 250V Yellow Welder Receptacle

SKU CH-243E-HBJN8

A 50-amp, 250-volt yellow welder receptacle compatible with a wide range of cable types

  • ETL verified for safety compliance
  • 50A 250V rating suits heavy-duty welding equipment
  • Compatible with SO, ST, SE and other common cable types
  • Yellow finish aids quick identification in workshop environments

2-Pack 50A 250V NEMA 6-50R Welder Receptacles

This two-pack supplies a pair of yellow NEMA 6-50R female receptacles rated for 50 amps at 250 volts. Each unit is ETL verified and designed as a direct replacement for welder power connections. The sockets accept a wide range of flexible cable types including SO, ST, SE and their oil- or weather-resistant variants. They suit workshops or fabrication areas needing reliable high-current outlets.

Thermals noise and power draw in normal use

The receptacles are passive wiring devices that generate no audible noise and draw no power themselves. Heat produced during operation depends entirely on the connected load and the quality of the cable termination. Properly torqued connections on compatible cable keep temperature rise within normal limits for 50-amp service. No active cooling or external power supply is required.

Highlights

  • ETL verified for safety compliance
  • 50A 250V rating suits heavy-duty welding equipment
  • Compatible with SO, ST, SE and other common cable types
  • Yellow finish aids quick identification in workshop environments

Specifications

BrandLORDWORLD

Questions about this item

How do I wire the LORDWORLD NEMA 6-50R receptacle to a compatible cable like SOOW or STOOW?

Strip the cable jacket and conductors to the terminal depth, match the two hot wires to the brass screws and the ground to the green screw, then tighten each terminal firmly so no copper strands escape.

What maintenance does the LORDWORLD 50A 250V yellow receptacle need after installation?

Inspect the contact blades and terminal screws periodically for discolouration or looseness, and replace the unit if the yellow housing shows heat damage or the spring tension feels weak.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.