LORDWORLD
LORDWORLD 2× 90° VGA 15-pin male-female angled adapters
Two 90-degree angled VGA 15-pin male-to-female adapters support 1080P at 60Hz for tight spaces
- Fits tight spaces with 90° angled connectors
- Two adapters included for up and down routing
- Supports 1080P at 60Hz video output
- Male to female design extends VGA connections
- Standard 15-pin HDB15 interface for broad compatibility
Two-pack 90° VGA angled adapters
This pair of 15-pin male-to-female adapters bends the cable ninety degrees up or down so the connector fits behind monitors or projectors where rear space is tight. Each unit has thumbscrews on the plug and screw nuts on the socket for a secure lock. The set suits anyone extending a VGA link in cramped desk or ceiling-mount setups.
Passive signal path no power draw
The adapters contain no active electronics so they add no heat, no fan noise and draw zero power from the source. Video passes straight through the 15-pin HDB15 contacts at the rated 1080P 60Hz without amplification or conversion. They simply reroute the existing analogue RGB signal around physical obstacles.
Mechanical relief for fragile ports
By taking the strain off the device's own VGA socket the angled bodies reduce wear from repeated cable insertion or accidental tugs. The screw-lock nuts keep the connection firm during projector repositioning or monitor swivel. Users needing longer cable runs or digital-only outputs such as HDMI will need a separate active converter.
Highlights
- Fits tight spaces with 90° angled connectors
- Two adapters included for up and down routing
- Supports 1080P at 60Hz video output
- Male to female design extends VGA connections
- Standard 15-pin HDB15 interface for broad compatibility
Specifications
| Brand | LORDWORLD |
|---|
Questions about this item
How do I fit the 90° VGA adapter into a tight port without stripping the thumbscrews?
Align the 15-pin male plug straight into the female port, then finger-tighten the thumbscrews before snugging with a small screwdriver; forcing at an angle bends pins.
Will the screw nuts on the female end loosen over time and need re-tightening?
The captive screw nuts on the 15-pin female connector can be checked annually and re-tightened by hand if vibration from monitor movement causes play.
At what point does the 1080P@60Hz signal degrade on a long cable run through these adapters?
Signal loss appears first as colour fringing or sync drop beyond about 15 metres total cable length; keep combined run shorter for stable 60 Hz image.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.



