LONGER
LONGER 20W Laser Engraver Module Dual Beam 0.08*0.1mm Spot for RAY5
A 20W dual-beam laser module with a 0.08*0.1mm spot upgrades the RAY5 for finer engraving and cuts 15mm pine or 8mm acrylic in one pass
- Finer detail from 0.08 x 0.1 mm laser spot
- 256-level colour scale enables multi-tone engraving
- 20 W optical output cuts 15 mm pine in one pass
- Cuts 8 mm acrylic or 0.05 mm stainless steel
- Air-assist port keeps surfaces cleaner during cuts
20W Laser Module for RAY5
The LONGER 20W laser engraver module is a dual-beam upgrade head designed for the RAY5 machine. It delivers 20W optical output with a compressed 0.08*0.1mm spot and a 256-bit colour scale for detailed, multi-colour engraving. A 32-bit motherboard drives the module, while a reserved air-assist interface accepts external pumps for cleaner cuts.
Makers wanting finer detail on RAY5
This module suits owners of the RAY5 engraver who need a smaller spot size and stronger cutting performance than the standard head provides. It is not for users who require a standalone laser system, a different mounting pattern, or compatibility with other engraver brands. Buyers without an air pump will miss the full benefit of the assisted-cutting design.
Sustained cutting with air assist
Under continuous operation the 20W module cuts 15mm pine and 8mm acrylic in a single pass, and reaches 25mm wood or 35mm acrylic over multiple passes. It also scores 0.05mm stainless steel. The air-assist connection clears debris during long runs, keeping the 0.08*0.1mm focus stable and preventing residue build-up that would otherwise degrade edge quality.
Highlights
- Finer detail from 0.08 x 0.1 mm laser spot
- 256-level colour scale enables multi-tone engraving
- 20 W optical output cuts 15 mm pine in one pass
- Cuts 8 mm acrylic or 0.05 mm stainless steel
- Air-assist port keeps surfaces cleaner during cuts
Specifications
No published specifications for this item yet.
Questions about this item
Does this 20W module mount directly on my existing RAY5 frame without extra brackets?
The module is designed as a DIY laser head for the RAY5 engraver, so it fits the machine's native mounting pattern and connects to the on-board 32-bit motherboard.
Will the 0.08*0.1mm compressed spot still engrave cleanly if I keep my older air pump instead of buying a new one?
An air-assist interface is reserved on the module, allowing various air pumps to be attached for cleaner surfaces during engraving and cutting.
How can I verify the 256-bit colour scale is active after I install the module?
Run a greyscale test pattern; smooth transitions across 256 levels with no banding confirm the upgraded motherboard and fine 0.08*0.1mm spot are functioning correctly.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
