We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Two black Y-splitter cables for RGB LED strips, 30cm long

LIVEDITOR LIGHTING

LIVEDITOR LIGHTING 4 Pin LED Splitter Cable 1 to 2 Splitter Black 2pcs 30cm

SKU CH-J2TG-4KQ3P

Splits one 4-pin RGB LED strip signal into two for SMD 5050, 3528, 2835 tapes, 30 cm each, pack of two

  • FeaturesBlack 1 to 2 Splitter Cable (2pcs)
  • Splits one controller signal to two RGB strips
  • 30 cm length suits compact installations
  • Supports 5050, 3528 and 2835 SMD LED types
  • Includes two splitter cables and six male plugs
  • Black finish blends with most strip housings

4-Pin RGB LED Strip Splitter

This 4-pin LED splitter cable connects two SMD 5050, 3528 or 2835 RGB LED strips to a single controller. It suits DIY lighting projects where one power source must drive two separate tape runs. The 30cm length keeps cable routing tidy inside cabinets, coves or sign boxes. Buyers who need to split more than two strips will need additional splitters or a different distribution method.

Bundled Male 4-Pin Plugs

The package includes six male 4-pin plugs alongside the two Y-splitter cables. These plugs let you terminate bare strip ends without soldering, so cut sections become ready-to-connect leads. Extra plugs remain for future cuts or repairs, reducing the need to order separate connector kits. Users who prefer soldered joints or use waterproof connectors will not use the supplied plugs.

Plug-and-Play Installation

Each splitter and plug uses a friction-fit 4-pin header that pushes onto the strip contact pads; no tools are required. Alignment is key — reversing the plug swaps colour channels and dims the output. A power supply with sufficient amperage for both strips must be verified before powering on, otherwise the controller may shut down or the strips will run dim.

Highlights

  • Splits one controller signal to two RGB strips
  • 30 cm length suits compact installations
  • Supports 5050, 3528 and 2835 SMD LED types
  • Includes two splitter cables and six male plugs
  • Black finish blends with most strip housings

Specifications

FeaturesBlack 1 to 2 Splitter Cable (2pcs)

Questions about this item

Will the 4-pin connectors on the splitter cables wear out and need replacing?

The cables use standard 4-pin connectors rated for typical LED strip installations; no periodic replacement is expected under normal indoor use.

What limits how many 5050 or 3528 strips I can run from one 1-to-2 splitter?

The splitter divides one signal into two outputs, so the power supply amperage must cover the combined draw of both connected strips.

Do the 30 cm cables get warm when driving two RGB strips all day?

The short 30 cm length and quality cable keep voltage drop and heat low during continuous operation.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.