We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White nylon push-fit tee fitting with three 1/2 inch ports

Liquifit

Liquifit 6508 62 22WP2 Push-Fit Tee Fitting 1/2 in Nylon White

SKU CH-P59J-KKDJN

Push-fit tee fitting joins 1/2 in nylon tubing for potable water or CO₂ lines at up to 230 psi

  • Push-fit design enables tool-free installation on 1/2 in tubing
  • Nylon construction resists corrosion for potable water and CO₂ systems
  • Rated to 230 psi for reliable high-pressure performance
  • 1/2 in NPTF male thread with pre-applied sealant speeds assembly
  • White finish provides clean, identifiable connections in plumbing layouts

1/2 in Push-Fit Tee Fitting

The Liquifit 6508 62 22WP2 is a nylon tee fitting designed for 1/2 inch tube connections. It joins one NPTF threaded port with two push-to-connect ports in a single white fitting. The fitting suits potable water and carbon dioxide lines. It is not intended for builders who need a different tube diameter or thread standard.

Sustained Pressure Performance

The fitting carries a maximum operating pressure of 230 psi for continuous service. The nylon body and push-to-connect ends maintain their seal under steady load without the risk of loosening that can affect threaded-only joints. The design avoids the fatigue that repeated pressure spikes can cause in softer materials. It is not suited for systems that regularly exceed the rated pressure.

Interface Practical Limits

The push-to-connect ends accept 1/2 inch outer diameter tubing for tool-free assembly. The NPTF side seals on the thread form itself, so separate thread sealant is not required. The 1/2 inch pipe size on the threaded port matches the tube ports for consistent flow area. Installers who need a different port configuration or a metal body must choose another fitting.

Highlights

  • Push-fit design enables tool-free installation on 1/2 in tubing
  • Nylon construction resists corrosion for potable water and CO₂ systems
  • Rated to 230 psi for reliable high-pressure performance
  • 1/2 in NPTF male thread with pre-applied sealant speeds assembly
  • White finish provides clean, identifiable connections in plumbing layouts

Specifications

BrandLIQUIFIT

Questions about this item

Will the 230 psi rating hold up when the fitting runs continuously with potable water?

The fitting is rated for a maximum operating pressure of 230 psi and is approved for potable water applications.

Do I need to supply my own 1/2 in tubing to connect to the push-to-connect ends?

Yes, the push-to-connect ports accept 1/2 in outer-diameter tubing that you provide.

Can the 1/2 in NPTF male thread on side A mate with my existing brass fittings?

The NPTF thread on side A is designed to seal with standard 1/2 in NPT or NPTF female threads, including brass.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.