We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White nylon push-fit tee fitting with three ports, pack of ten

Liquifit

Liquifit 6508 60 14Wp2 Push-Fit Tee Fitting 3/8 in Nylon White Pack of 10

SKU CH-RSV7-WJ9C4

White nylon push-fit tee fitting connects 3/8 in tube to 1/4 in NPTF thread at 230 psi, supplied in a pack of 10

  • Push-fit design speeds installation on potable water and CO₂ lines
  • Nylon body rated to 230 psi for reliable pressure handling
  • 1/4 in NPTF male thread with dual 3/8 in push-to-connect branches
  • White finish identifies potable-water circuits at a glance
  • Pack of 10 fittings covers multiple connection points

3/8 in Push-Fit Tee Fitting

The Liquifit 6508 is a white nylon tee fitting designed for 3/8 inch outer diameter tubing on its two push-to-connect ports. It suits plumbing tasks involving potable water or carbon dioxide lines where a branch connection is required. The pack contains ten fittings for multiple installations.

Quick Push-to-Connect Installation

The push-fit ends allow tubing to be inserted by hand without tools or separate clamps, while the 1/4 in NPTF threaded end seals with standard thread tape or compound. Ensure tubing is cut square and fully seated to avoid leaks; debris on the tube surface can prevent a reliable seal.

Pressure and Chemical Limits

The fitting is rated for a maximum operating pressure of 230 psi and is constructed from nylon compatible with potable water and carbon dioxide service. California Proposition 65 warnings apply because the material contains a listed chemical. Do not exceed the pressure rating or use with fluids outside the stated applications.

Highlights

  • Push-fit design speeds installation on potable water and CO₂ lines
  • Nylon body rated to 230 psi for reliable pressure handling
  • 1/4 in NPTF male thread with dual 3/8 in push-to-connect branches
  • White finish identifies potable-water circuits at a glance
  • Pack of 10 fittings covers multiple connection points

Specifications

BrandLIQUIFIT

Questions about this item

How do I confirm the 6508 tee is sealing correctly after I push the 3/8 in tubing onto both push-to-connect ends?

Pressurise the line up to the 230 psi maximum operating pressure and watch for leaks at each push-to-connect joint; the pre-applied thread sealant on the 1/4 in NPTF side should prevent weeping there.

What comes in the pack and what extra parts are needed to complete a potable-water or CO₂ line?

The box contains ten white nylon 6508 tee fittings with 3/8 in tube outer diameter on the two push-to-connect ports and a 1/4 in NPTF male thread on the third port; you must supply 3/8 in tubing and a matching 1/4 in NPTF female adapter.

The listing shows only one version — how do I choose the right capacity for my system?

This single SKU is a pack of ten identical 3/8 in OD push-to-connect tees rated to 230 psi, so capacity is fixed; buy multiple packs if you need more than ten tees.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.