We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
White nylon push-fit tee fitting with three 1/4 inch connections

Liquifit

Liquifit 6508 56 14WP2 Push-Fit Tee Fitting 1/4 in White 10

SKU CH-04MM-5Q7W6

White nylon push-fit tee connects three 1/4 in lines for potable water or CO₂ at 230 psi, supplied in a pack of 10

  • Push-fit design speeds installation without tools
  • Nylon construction resists corrosion in potable water systems
  • 230 psi rating handles standard pressure demands
  • 1/4 in connections suit common tubing sizes
  • Pack of 10 fittings covers multiple connection points

LIQUIFIT 6508 Tee for CO2 and Water Lines

The LIQUIFIT 6508 push-fit tee fitting connects 1/4 inch tubing in fluid systems handling carbon dioxide and potable water. Its white nylon body resists corrosion while the push-to-connect ends on two ports allow quick assembly without tools. The third port uses a 1/4 inch NPTF thread for secure attachment to threaded components. Supplied in a pack of 10, these fittings suit new installations or maintenance work on compatible piping networks.

Suitable for 1/4 inch Tubing and NPTF Ports

This fitting suits installers joining three 1/4 inch connections where two are push-fit tubes and one is a male NPTF thread. It is not for applications requiring a different tube diameter, a different thread standard, or a fitting material other than nylon. Systems operating above the rated pressure or conveying fluids incompatible with nylon should use alternative components. The pre-applied thread sealant is not included, so the installer must provide a compatible sealant for the threaded joint.

Maximum Operating Pressure 230 psi

The single specification that determines suitability is the maximum operating pressure of 230 psi. Verify that the system design pressure stays at or below this limit before selecting the fitting. Exceeding this pressure risks leaks or failure, so the fitting must not be used in higher-pressure circuits. All other dimensions and connection types are fixed by the 1/4 inch tube and thread standards listed.

Highlights

  • Push-fit design speeds installation without tools
  • Nylon construction resists corrosion in potable water systems
  • 230 psi rating handles standard pressure demands
  • 1/4 in connections suit common tubing sizes
  • Pack of 10 fittings covers multiple connection points

Specifications

BrandLIQUIFIT

Questions about this item

Will the 1/4 in push-to-connect ends grip the 1/4 in tubing I already have without leaks?

Yes, both push-to-connect ports are sized for 1/4 in tube outer diameter and the fitting is rated to 230 psi.

How can I confirm the tee is sealed and flowing after I press the tubes in?

Pressurise the line up to 230 psi and check that no water or CO₂ escapes at the three joints.

The pack says 10 pieces; does that include any NPTF thread sealant or tube inserts?

The box contains ten white nylon tee fittings with 1/4 in NPTF male thread and two 1/4 in push-to-connect branches; thread sealant and tube inserts are not included.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.