Lincoln Electric
Lincoln Electric KP42-3035-15 Liner 0.035 in 15 ft
Steel cable liner for Lincoln Magnum 250L and SP250 MIG guns, 15 ft long with 0.035 in wire capacity
- TypeTools
- 15 ft steel liner feeds wire smoothly to the gun
- 035 in bore matches common MIG wire sizes
- Fits Lincoln Magnum 250L and SP250 guns directly
- Gray steel construction resists wear during long runs
- Cable liner design protects wire from kinks and snags
Lincoln Electric KP42-3035-15 Cable Liner
This 15 ft steel cable liner is built for MIG welding guns. It fits Lincoln Magnum 250L and SP250 models directly. The grey liner handles wire diameters from 0.03 in to 0.035 in. A 0.05 in bore guides the wire smoothly.
Suits owners of Magnum 250L
Buyers using other gun brands or models cannot use this part. Welders running wire thicker than 0.035 in need a different bore size. Shops requiring a longer or shorter length must look elsewhere.
Critical spec: 0.035 in maximum wire diameter
This liner accepts wire up to 0.035 in and down to 0.03 in. The 0.05 in bore matches this range exactly. Exceeding the maximum diameter will cause feeding problems. Verify your wire size before ordering.
Highlights
- 15 ft steel liner feeds wire smoothly to the gun
- 035 in bore matches common MIG wire sizes
- Fits Lincoln Magnum 250L and SP250 guns directly
- Gray steel construction resists wear during long runs
- Cable liner design protects wire from kinks and snags
Specifications
| Brand | LINCOLN ELECTRIC |
|---|---|
| Type | Tools |
Questions about this item
How do I install the KP42-3035-15 liner in my Magnum 250L gun without damaging the 0.05 in bore?
Unscrew the gun's rear connector, feed the 15 ft steel liner through the cable assembly, seat the tapered end firmly into the power pin, then trim excess at the front before reattaching the nozzle.
When should I replace this 0.035 in liner if I run 0.03 in wire daily?
Replace when wire feed becomes erratic or the gray steel shows visible wear grooves inside the 0.05 in bore, typically after several thousand pounds of wire.
At what duty cycle does the 15 ft steel liner heat up enough to affect 0.035 in wire feed consistency?
The steel liner handles heat from the Magnum 250L or SP250 at rated output; feed issues appear first from bore wear or kinks, not liner temperature.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
