Lift-all
Lift-all TE61013 ratchet tie-down strap 27 ft 2 in 3330 lb
Heavy-duty ratchet strap with 27 ft length, 2 in width and 3,330 lb working load limit
- MaterialHAWA
- 3,330 lb working load limit secures heavy cargo
- 10,000 lb/in tensile strength resists sudden shock loads
- 27 ft overall length reaches across wide loads
- Cut-resistant polyester edges extend strap service life
- CVSA, FMCSA and US DOT compliant for commercial transport
Lift-all TE61013 ratchet tie-down
The Lift-all TE61013 is a 27 ft ratchet strap built for securing heavy cargo. It serves truckers, fleet operators and anyone moving loads that demand a 3,330 lb working load limit. The high-visibility green webbing makes the strap easy to spot on a busy deck or in low light. Cut-resistant edges help the polyester webbing survive contact with sharp corners.
Thermal noise and power draw
This is a manual tensioning tool with no motor, electronics or power supply. It produces no heat and no audible noise beyond the ratchet clicks during tightening. No electricity or fuel is consumed in normal use. The operator provides all force through the ratchet handle.
Build quality and daily implications
The strap uses polyester webbing with cut-resistant edges and steel chain-extension grab hooks at each end. The fixed end measures 16 in while the overall length reaches 27 ft. Hardware meets CVSA, FMCSA and US DOT standards for commercial tie-down use. The ratchet mechanism adjusts tension quickly and locks securely for transport.
Highlights
- 3,330 lb working load limit secures heavy cargo
- 10,000 lb/in tensile strength resists sudden shock loads
- 27 ft overall length reaches across wide loads
- Cut-resistant polyester edges extend strap service life
- CVSA, FMCSA and US DOT compliant for commercial transport
Specifications
| Brand | LIFT-ALL |
|---|---|
| Material | HAWA |
Questions about this item
How do I install the Lift-all TE61013 ratchet strap and what step is often missed?
Thread the webbing through the ratchet mandrel from underneath, pull slack tight by hand, then crank the handle; the step often missed is leaving at least two full wraps on the drum so the strap cannot slip under load.
What maintenance or replacement will the 2 in polyester strap with cut-resistant edges need later?
Inspect the entire 27 ft length before each use; replace the strap if you find cuts, abrasion exposing core fibres, melted fibres, or if the chain-extension grab-hook shows deformation or cracked welds.
What limit appears first during sustained tension on this 3,300 lb working-load strap?
The 3,300 lb working load limit is reached before the 10,000 lb/in tensile rating; do not exceed 3,300 lb in service or the ratchet and hook assembly may yield.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
