We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Silver 1U rackmount switch with 48 RJ45 ports and four SFP+ uplinks

Lenovo

Lenovo CE0152PB 48-port 10/100/1000Base-T 4x10G SFP+ Layer 3 network switch

SKU CH-HBH4-0X4T8 MPN CE0152PB

A 48-port Gigabit Layer 3 switch with four 10G SFP+ uplinks and PoE for powering access points and cameras

  • FormatRackmount
  • Network Management TypeLayer 3 Switch
  • Uplink InterfaceSFP
  • Primary PortsGigabit Ethernet 48 x Gigabit Ethernet Network 4 x 10 Gigabi
  • Primary Port Speed10GBase-X 10/100/1000Base-T
  • Uplink SpeedSFP
  • 48 Gigabit ports connect dozens of wired devices
  • Four 10 GbE SFP+ uplinks handle high-speed backbone traffic
  • Layer 3 routing moves packets between subnets without extra hardware
  • PoE on every RJ-45 port powers phones cameras and access points
  • 1U rackmount form factor fits dense cabinet deployments

48-port Layer 3 rackmount switch

The Lenovo CE0152PB is a 1U rackmount Layer 3 switch that provides 48 fixed 10/100/1000BASE-T RJ-45 ports with Power over Ethernet and four SFP+ uplink ports supporting 1 GbE and 10 GbE transceivers, AOCs and DAC cables. It is built for access-layer deployments where space and power are at a premium.

Branches, retail and campus access layers

This switch suits branch offices, retail sites, workgroups and campus networks that need PoE for phones, cameras and wireless access points alongside 10 GbE uplinks. It is not for buyers who require more than 48 copper ports in a single appliance or who need uplink speeds beyond 10 GbE.

48 PoE+ ports with four 10 GbE SFP+ uplinks

The deciding specification is the combination of 48 PoE-enabled Gigabit copper ports and four SFP+ slots that accept 1 GbE or 10 GbE optics and cables. If your design needs that exact port count and uplink flexibility in a 1U form factor, this model matches the requirement.

Highlights

  • 48 Gigabit ports connect dozens of wired devices
  • Four 10 GbE SFP+ uplinks handle high-speed backbone traffic
  • Layer 3 routing moves packets between subnets without extra hardware
  • PoE on every RJ-45 port powers phones cameras and access points
  • 1U rackmount form factor fits dense cabinet deployments

Specifications

Brandlenovo
FormatRackmount
Network Management TypeLayer 3 Switch
Uplink InterfaceSFP
Primary PortsGigabit Ethernet 48 x Gigabit Ethernet Network 4 x 10 Gigabit Ethernet Expansion Slot 10 Gigabit Ethernet
Primary Port Speed10GBase-X 10/100/1000Base-T
Uplink SpeedSFP
StackableRack-mountable
Layer3
PowerPower Supply

Questions about this item

Do I need SFP+ transceivers or DAC cables to use the four 10 GbE uplink ports on this switch?

Yes, the 4x SFP+ ports require compatible 1 GbE or 10 GbE optical transceivers, active optical cables, or direct attach copper cables, which are not included with the switch.

Can my existing 10/100 Mbps devices connect to the 48 RJ-45 ports without configuration changes?

The 48 fixed ports auto-negotiate 10/100/1000BASE-T speeds, so legacy 10/100 Mbps devices will link automatically at their maximum supported rate.

How can I verify the switch is forwarding traffic at Layer 3 after initial setup?

Configure an IP address on a VLAN interface, ping between devices in different VLANs, and check the routing table with the CLI show ip route command to confirm inter-VLAN routing is active.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.