We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in

Lemincrash

Lemincrash Power Extension Cord Kit Black 18AWG 30cm 12 clips

SKU CH-K4H1-S71EK

Black 18 AWG PSU extension kit with 24-pin ATX, CPU and dual GPU cables plus 12 clips at 30 cm length

  • ColorBlack
  • Length11" - 15"
  • Terminal GenderMale to Female
  • SpeedTest
  • ConductorCopper Conductor
  • Black sleeved cables keep builds tidy
  • 30 cm extensions reach components without slack
  • 18 AWG copper handles high current safely
  • Kit covers ATX 24-pin, dual PCI-E and CPU power
  • 12 clips secure routing for clean airflow

Kit Contents

The Lemincrash Power Extension Cord Kit supplies a 24-pin ATX cable, two PCI-E 8(6+2)-pin GPU cables, one CPU 8(4+4)-pin EPS cable and twelve cable-management clips. Each lead uses 18 AWG copper conductors with male-to-female terminals finished in black. The kit targets builders who want to route standard PSU cables cleanly behind a motherboard tray or through a basement compartment.

Thermals and Power

The 18 AWG copper conductors handle the current levels defined by the ATX and EPS specifications without measurable voltage drop across the 30 cm length. Passive operation adds no fan noise, and the short runs keep resistive losses negligible inside a typical chassis. Builders who need longer runs or higher ampacity should look for a larger gauge.

Build and Connectors

Black sleeving gives a uniform look while protecting the insulation during routing. The twelve included clips secure cables to case cut-outs or tie-down points, reducing strain on motherboard and GPU headers. Male-to-female ends plug directly into existing PSU cables, so no re-pinning or modular-cable compatibility checks are required.

Highlights

  • Black sleeved cables keep builds tidy
  • 30 cm extensions reach components without slack
  • 18 AWG copper handles high current safely
  • Kit covers ATX 24-pin, dual PCI-E and CPU power
  • 12 clips secure routing for clean airflow

Specifications

ColorBlack
Length11" - 15"
Terminal GenderMale to Female
SpeedTest
ConductorCopper Conductor

Questions about this item

How do I route the 30 cm ATX 24-pin extension behind the motherboard tray without bending the 18 AWG wires too sharply?

Feed the male end through the rear cut-out first, then fold the cable in a wide loop before plugging the female end into the board; the 300 mm length leaves just enough slack for one gentle curve.

When should I replace the 12 included cable-management clips if they lose grip?

Swap clips once the locking tab no longer snaps shut or the adhesive pad peels away from the case panel; the kit supplies exactly 12 so you can refresh a full build at once.

What thermal limit appears first when the 18 AWG copper conductors run a GPU at full load for hours?

The 18 AWG gauge is rated for the current drawn by an 8(6+2) pin GPU connector; sustained loads will hit the insulation temperature rating before voltage drop becomes an issue.

New to this? Which coin should you pay with — what to check, what it costs to pay, and what is never asked for.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.