We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Small brass flow control regulator with 4mm push-to-connect inlet and M5 thread outlet

Legris

Legris 7010 04 19 Flow Control Regulator 4mm

SKU CH-HDNJ-Y3NCV MPN 7010

A 4 mm push-to-connect flow control regulator with M5×0.8 outlet, 14.5–145 psi range and 158 °F maximum temperature

  • TypeDrain Components
  • Precise flow adjustment with 360-degree rotation control
  • Secure 4mm push-to-connect inlet for quick installation
  • M5 x 0.8 outlet thread fits standard fittings
  • Operates reliably from 14.5 to 145 psi pressure range
  • Withstands temperatures up to 158°F for demanding environments

Legris 7010 Flow Control Regulator

This Legris 7010 regulator manages pneumatic flow in a single direction for 4mm push-to-connect tubing. It suits automation builders who need precise speed adjustment on compact actuators. The M5 x 0.8 outlet thread fits standard miniature ports. It is not for systems requiring bidirectional metering or larger tube diameters.

145 psi Pressure Range and 158°F Limit

The valve operates reliably between 14.5 and 145 psi, covering typical shop-air pressures with comfortable headroom. At the upper end, 145 psi marks the hard ceiling; sustained spikes above this risk seal failure. The 158°F temperature cap means it cannot handle high-heat compressor discharge lines or steam-adjacent circuits.

Push-to-Connect and M5 Interface Constraints

The 4mm push-to-connect inlet allows tool-free tube insertion but locks you to that exact outside diameter. The M5 x 0.8 outlet demands matching threaded ports; adapters add length and potential leak paths. Full 360° rotation eases alignment in tight manifolds, yet the single controlled direction prevents use in reversible cylinder circuits without a second valve.

Highlights

  • Precise flow adjustment with 360-degree rotation control
  • Secure 4mm push-to-connect inlet for quick installation
  • M5 x 0.8 outlet thread fits standard fittings
  • Operates reliably from 14.5 to 145 psi pressure range
  • Withstands temperatures up to 158°F for demanding environments

Specifications

TypeDrain Components
BrandLegris
Model7010 04 19

Questions about this item

Will the 4 mm push-to-connect inlet fit the 4 mm tubing I already use?

The inlet port is a 4 mm push-to-connect fitting, so it accepts standard 4 mm pneumatic tubing directly.

How can I confirm the regulator is operating correctly once installed?

Adjust the knob through its 360-degree rotation; flow should change smoothly and hold steady between 14.5 and 145 psi up to 158 °F.

Does the package include the M5 male fitting for the outlet or must I buy it separately?

The outlet is a built-in M5 × 0.8 male thread, so no separate fitting is needed for that connection.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.