We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with 16mm tube ends and 1/2in male thread

Legris

Legris 3198 16 21 Male Branch Tee Trap 16mm 1/2in

SKU CH-DCSC-P1R24 MPN 3198

Push-fit branch tee connects two 16 mm tubes to a 1/2 in male BSPP thread for air, cutting fluids or inert gases

  • TypeDrain Components
  • ColorBlack
  • Push-to-connect ends allow tool-free assembly on 16 mm tubing
  • Male BSPP branch threads directly into 1/2 in ports without extra adapters
  • Pre-applied thread sealant cuts installation time on pneumatic lines
  • Fibreglass-reinforced nylon body resists cutting fluids and inert gases
  • Black finish identifies the fitting in colour-coded air systems

Push-Fit Tee for 16 mm Tubing

The Legris 3198 16 21 is a male branch tee fitting designed to connect two 16 mm outer-diameter tubes to a 1/2 in male BSPP thread. Its fiberglass-reinforced nylon body uses push-to-connect ends on the tube sides for tool-free installation in fluid systems.

For Air and Inert-Gas Lines Only

This fitting suits pneumatic circuits, cutting-fluid delivery and inert-gas distribution where push-fit convenience is required. It is not intended for potable water, high-pressure hydraulic service or applications that demand metal threads or specific chemical certifications beyond the stated Prop 65 notice.

16 mm Tube OD with 1/2 in Male Thread

The defining specification is the combination of 16 mm push-fit ports on the run and a 1/2 in MBSPP branch; if your tubing or port size differs, this tee will not seal correctly.

Highlights

  • Push-to-connect ends allow tool-free assembly on 16 mm tubing
  • Male BSPP branch threads directly into 1/2 in ports without extra adapters
  • Pre-applied thread sealant cuts installation time on pneumatic lines
  • Fibreglass-reinforced nylon body resists cutting fluids and inert gases
  • Black finish identifies the fitting in colour-coded air systems

Specifications

TypeDrain Components
ColorBlack
BrandLegris
Model3198 16 21

Questions about this item

What tube size do I need on hand for the two push-to-connect ports on this Legris 3198 fitting?

Both push-to-connect ends accept 16 mm outside-diameter tube.

Can I thread the male BSPP branch into an existing 1/2 in female port on older equipment?

Yes, the branch is a 1/2 in MBSPP thread made for that connection.

How do I confirm the push-to-connect joints are sealed after assembly?

Pressurise the line with air or inert gas and check for bubbles or pressure drop.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.