Legris
Legris 3184 56 00 push-fit elbow fitting 1/4 in tube
Push-fit elbow joins two 1/4-inch tubes at 90 degrees, rated to 290 psi and 176 °F in black fiberglass-reinforced nylon
- TypeDrain Components
- MaterialHAWA
- ColorBlack
- Quick 90° turns with push-to-connect 1/4 in tube ends
- Reliable seal up to 290 psi working pressure
- Handles heat up to 176 °F in air lines
- Fibre-reinforced nylon body resists corrosion and impact
- Ready to install with no thread sealant required
Push-Fit Elbow for 1/4 in Tube
This Legris 3184 push-fit elbow connects 1/4 in tubing in air systems. The fiberglass-reinforced nylon body accepts tube on both ends without tools. It suits maintenance teams and OEM assemblers who need quick, leak-tight direction changes in pneumatic circuits.
Pressure and Temperature Limits
The fitting is rated for 290 psi maximum operating pressure and 176 degrees F maximum operating temperature. These limits define the safe envelope for compressed-air lines; exceeding either value risks deformation or seal failure. No thread sealant is included or required with the push-to-connect design.
Replaces Threaded or Barbed Elbows
This elbow replaces traditional threaded or barbed fittings where faster assembly and tool-free disconnection are priorities. The jump is worthwhile when downtime for re-plumbing must be minimal and the system stays within the stated pressure and temperature range. Buyers needing metal bodies or higher temperature ratings should look elsewhere.
Highlights
- Quick 90° turns with push-to-connect 1/4 in tube ends
- Reliable seal up to 290 psi working pressure
- Handles heat up to 176 °F in air lines
- Fibre-reinforced nylon body resists corrosion and impact
- Ready to install with no thread sealant required
Specifications
| Type | Drain Components |
|---|---|
| Material | HAWA |
| Color | Black |
| Brand | Legris |
| Model | 3184 56 00 |
Questions about this item
Should I choose the 3184 56 00 elbow or a straight connector for my 1/4 in tubing?
Select the 3184 56 00 elbow when you need a 90-degree turn in a 1/4 in push-fit line; use a straight connector only for in-line joins.
What does the 290 psi rating mean when the fitting is installed in my air system?
The 290 psi maximum operating pressure is the highest sustained air pressure the push-fit joint can hold at up to 176 Degrees F without leaking or blowing off.
How does the push-to-connect interface limit the tube I can use?
The push-to-connect end accepts only 1/4 in outer-diameter tubing; the stem end inserts into another 1/4 in push-fit port, so both sides are locked to that single size.
Also in this aisle
People compared these
Same shelf, same checkout — eight coins and a 30-minute rate lock.
