We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit tee fitting with two 1/4 inch push-to-connect ends and a tube stem, pack of 10

Legris

Legris 3183 56 00 Plug-In Run Tee 1/4 In PK10

SKU CH-AXTX-KHBPS MPN 3183

Push-fit brass-and-nylon tee joins two 1/4 in tubes and one tube stem for 290 psi air lines, pack of 10

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect ends speed up air-line assembly
  • Brass and reinforced nylon body handles 290 psi
  • Black finish resists grime in workshop environments
  • Ten-piece pack keeps spare fittings on hand
  • Stem-and-push layout suits branched pneumatic circuits

Push-Fit Tee for Air Lines

The Legris 3183 56 00 is a brass and fiberglass-reinforced nylon tee designed for pneumatic circuits. It connects three points using push-to-connect ports on the run and a tube stem on the branch. The fitting handles a maximum operating pressure of 290 psi and is supplied in a pack of 10.

Installers needing a compact branch connection

This tee suits maintenance engineers and OEM assemblers who want a tool-free joint on 1/4 in tubing. It is not intended for hydraulic systems or pressures above the rated limit. Buyers who require threaded ports or a different tube diameter should select another fitting.

1/4 in tube outer diameter on both push-to-connect

The run ports accept 1/4 in outside-diameter tube while the branch provides a 1/4 in tube stem. This single dimension determines whether the fitting matches the existing tubing in the circuit.

Highlights

  • Push-to-connect ends speed up air-line assembly
  • Brass and reinforced nylon body handles 290 psi
  • Black finish resists grime in workshop environments
  • Ten-piece pack keeps spare fittings on hand
  • Stem-and-push layout suits branched pneumatic circuits

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3183 56 00

Questions about this item

How do I install the Legris 3183 56 00 push-to-connect tee, and what is the step people often miss?

Push the 1/4 in tube firmly into both push-to-connect ports until it seats against the internal collet; the step often missed is pulling back on the tube to confirm the grab ring has locked.

What maintenance or replacement will the brass and fiberglass-reinforced nylon tee need later?

Inspect the O-rings and collet teeth periodically for wear or debris; replace the fitting if the sealing surface shows cracking or if leaks appear at the 1/4 in connections.

What limit appears first when the tee runs continuously at its 290 psi maximum operating pressure?

The 290 psi pressure rating is the primary limit; sustained operation at this level can accelerate seal fatigue and reduce the fitting's service life.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.