We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Brass push-fit connector, silver finish, 10 mm tube to 1/4 NPT male thread

Legris

Legris 3175 10 14 Male Conn 10mm OD 1/4 NPT Trap

SKU CH-P350-Z2XJT MPN 3175

Push-fit brass fitting connects 10 mm tube to 1/4 NPT male thread with pre-applied sealant, rated to 290 psi and 175 °F

  • TypeDrain Components
  • MaterialHAWA
  • Push-to-connect design enables tool-free tube installation
  • Brass C36000 body resists corrosion in demanding fluid systems
  • Pre-applied thread sealant eliminates need for separate tape or paste
  • 290 psi pressure rating supports high-pressure pneumatic circuits
  • 175 °F temperature limit suits elevated-heat applications

Brass Push-Fit Drain Fitting

The Legris 3175 10 14 is a brass push-to-connect drain component with a 10 mm tube port and a 1/4 inch male NPT thread. It carries a pre-applied thread sealant and is rated for 290 psi at up to 175 degrees F. The fitting is made from C36000 brass and supplied in packs of ten.

Suited for Vacuum and Fluid Lines

This fitting suits installers who need a quick-connect drain trap on 10 mm tubing with a standard 1/4 NPT male outlet. It is not for systems that require a different tube diameter, a female port, or a non-NPT thread form. Buyers needing higher pressure ratings or alternative materials should look elsewhere.

10 mm Push-to-Connect by 1/4 NPT Male

The critical specification is the combination of a 10 mm push-fit inlet and a 1/4 inch male NPT outlet. This exact end-configuration determines whether the part matches the tubing and port on the target equipment. Verify both dimensions before ordering.

Highlights

  • Push-to-connect design enables tool-free tube installation
  • Brass C36000 body resists corrosion in demanding fluid systems
  • Pre-applied thread sealant eliminates need for separate tape or paste
  • 290 psi pressure rating supports high-pressure pneumatic circuits
  • 175 °F temperature limit suits elevated-heat applications

Specifications

TypeDrain Components
MaterialHAWA
BrandLegris
Model3175 10 14

Questions about this item

What tube size must I already have for the 10 mm push-to-connect end to seal?

You need tubing with a 10 mm outer diameter; the push-to-connect side is sized for that exact OD.

Will the 1/4 NPT male thread mate with the female NPT ports on my existing brass manifold?

Yes, the Side B connection is a 1/4 inch MNPT thread, compatible with standard female NPT ports.

How can I verify the fitting is holding at the rated 290 psi after installation?

Pressurise the line to working pressure and check for leaks; the pre-applied sealant and C36000 brass body are rated to 290 psi at 175 °F.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.