We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit bulkhead union, 3/8 inch tube, pack of 10

Legris

Legris 3116 60 00 bulkhead union 3/8 in 290 psi PK10

SKU CH-BVCA-MX9KS MPN 3116

A push-fit bulkhead union joining two 3/8 in tubes, rated to 290 psi and 176 °F, supplied in a pack of ten

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-to-connect design speeds installation without tools
  • 290 psi rating handles demanding air-line pressure
  • Fiberglass-reinforced nylon body resists impact and corrosion
  • 176 °F maximum temperature suits hot-air systems
  • Pack of ten fittings covers multiple connection points

Bulkhead Union 3/8 in 290 psi

This Legris bulkhead union joins two 3/8 inch tubes with push-to-connect ends. It is built from black fiberglass-reinforced nylon and rated for 290 psi at up to 176 degrees F. The fitting measures 1 11/16 in overall length and comes in a pack of ten. No thread sealant is pre-applied.

Air-line installers needing a through-panel joint

Technicians assembling pneumatic circuits on panels or bulkheads will find this union matches the 3/8 inch tube size and 290 psi rating. Installers who require a threaded connection, a different tube diameter, or a higher temperature limit should look at other fittings.

290 psi maximum operating pressure

The 290 psi rating is the single figure that decides whether this union suits the system pressure. If the circuit runs above this value the fitting is not suitable; if it stays at or below 290 psi the union meets the pressure requirement.

Highlights

  • Push-to-connect design speeds installation without tools
  • 290 psi rating handles demanding air-line pressure
  • Fiberglass-reinforced nylon body resists impact and corrosion
  • 176 °F maximum temperature suits hot-air systems
  • Pack of ten fittings covers multiple connection points

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3116 60 00

Questions about this item

How can I verify the 3/8 in push-to-connect union is sealed and leak-free after installation?

Pressurise the line up to 290 psi and check for bubbles at both push-fit ends; the fitting is rated for 176 °F maximum operating temperature.

What comes in the PK10 pack and do I need any extra sealant or tools?

The pack contains ten black bulkhead unions made of fiberglass-reinforced nylon; no pre-applied thread sealant is included and no special tools are required for push-to-connect assembly.

Which Legris 3116 variant should I choose for a 3/8 in air line rated at 290 psi?

Select model 3116 60 00 — it matches 3/8 in tube OD on both sides, handles 290 psi and 176 °F, and is supplied in a pack of ten.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.