We take cryptocurrency — so the coins you hold can buy real hardware.Pay in crypto, spend it on real hardware. Free insured shipping worldwide over $399. Plain, unbranded boxes, sent from Germany.Free insured shipping over $399. Your rate is locked for 30 minutes once checkout opens.Rate locked 30 minutes. Every item sealed, serial-checked and covered by a 24-month warranty.Sealed, 24-month warranty.

Saved items Sign in
Black push-fit elbow fitting 4 mm tube 1/8 in thread

Legris

Legris 3113 04 10 Male Elbow 4 mm 1/8 in Trap

SKU CH-ZSXR-7TG7Q MPN 3113

Connects 4 mm tubing to a 1/8 in male thread with a push-fit elbow rated to 290 psi and 175 °F

  • TypeDrain Components
  • MaterialHAWA
  • ColorBlack
  • Push-fit installation saves time
  • 4 mm tube fits compact routing
  • 1/8 in MBSPT thread seals without tape
  • Fibreglass-reinforced nylon withstands 290 psi
  • Rated to 175 °F for hot-fluid lines

Push-Fit Elbow Fitting

This push-fit elbow fitting connects a 4 mm tube to a 1/8 in MBSPT thread. The body is made from fiberglass-reinforced nylon and comes in black. Pre-applied thread sealant is included on the threaded side for a ready-to-install seal. It is suited to vacuum applications up to 290 psi and 175 degrees F.

Vacuum System Builders

The fitting suits technicians assembling or repairing low-pressure vacuum lines that use 4 mm tubing and 1/8 in ports. It is not intended for installers who need a straight connector, a different tube diameter, or a non-threaded port configuration. Buyers requiring higher temperature or pressure ratings should look at alternative components.

4 mm Tube to 1/8 in MBSPT

The decisive specification is the combination of a 4 mm push-to-connect tube end and a 1/8 in MBSPT male thread. This exact interface match determines whether the fitting will join your existing tube and port without adapters. Verify both dimensions against your system before purchasing.

Highlights

  • Push-fit installation saves time
  • 4 mm tube fits compact routing
  • 1/8 in MBSPT thread seals without tape
  • Fibreglass-reinforced nylon withstands 290 psi
  • Rated to 175 °F for hot-fluid lines

Specifications

TypeDrain Components
MaterialHAWA
ColorBlack
BrandLegris
Model3113 04 10

Questions about this item

Does the Legris 3113 04 10 pack include thread sealant or must I buy it separately?

The push-fit elbow comes with pre-applied thread sealant on the 1/8 in BSPT side so no separate sealant is required for installation.

Should I choose the 4 mm tube version or a different diameter for my vacuum line?

This fitting is built for 4 mm outer-diameter tubing on the push-to-connect side and 1/8 in male BSPT on the threaded side; select it only when both those sizes match your circuit.

Will the 290 psi rating hold up on a hot engine bay that reaches 175 °F?

Yes, the fiberglass-reinforced nylon body is rated for 290 psi maximum operating pressure at temperatures up to 175 °F, covering typical automotive vacuum and low-pressure fluid circuits.

Also in this aisle

People compared these

Same shelf, same checkout — eight coins and a 30-minute rate lock.